ADIC SNMS 2.3 manual Support@adic.com

SNMS

If you plan to set up one or more software applications to share a CAUTION library, your media may be overwritten. Therefore, before proceeding

to Step 1 of Adding Tape Drives, refer to Sharing a library between applications on page 4-104 of the StorNext Management Suite Installation Guide for instructions on how to properly set up your software to prevent this situation.

Step 1 Click Next to continue through all the screens for the Add Tape Drive wizard.

NOTE	For SCSI, network, or fibre-attached libraries, the device must be matched with
	the correct slot on the Matched Devices With Slots screen. For direct SCSI-
	attached disks that are not fibre channel, you do not need to match the device
	with the correct slot because the matching is automatically done. If you need help
	with slot-to-drive associations, contact ATAC at 1-800-827-3822 or at
	support@adic.com.

Once the Status screen appears displaying successful completion of adding tape drives, click Next to return to the Tape Drive Introduction screen.

Step 2 Click Done when you are ready to start the next step of the software configuration process.

The ICW screen appears and displays the word Completed after Step 4: Add Tape Drive.

Step 3 Click Next to begin Step 5: Add Media.

The Add Media - Introduction screen appears (see Figure 2-11).

Installing SNMS 2-15