Hydraulic Diagram, Hydraulic Connection

HYDRAULIC DIAGRAM

HYDRAULIC CONNECTION

IMPORTANT: THE MANUFACTURER RECOMMENDS THE INSTALLATION OF A DESCALING FILTER, THEREFORE HE WILL NOT ACCEPT RESPONSI- BILITY FOR ANY DAMAGE CAUSED BY SCALE.

The machine can be installed as follows:

Table top installation:

Connect the mains pipe to the in-let electrovalve.

Check the pressure by the manometer, if it is over 1 bar, adjust it with the inside reducer.

Cabinet installation:

Place the machine on the cabinet, insert the pipe with the filter, the one-way valve and the float into the 15lt tank and the grey pipe into the 5 lt waste tank.

In order to discharge the coffee pucks into a bag, fix it up to the cabinet conveyer with the special hook and insert the chute under the espresso brewer.

Finally screw the machine on the cabinet.

PAYMENT SYSTEM CONNECTION

	12V PARALLEL	connect to keyboard connector COIN12V (see picture
	at page 7).
	24V PARALLEL	connect to keyboard connector COIN24V (see picture
	at page 7).
	EXECUTIVE / MDB	connect to the relative cables (optional)

After the payment system connection, you must set the kind of payment system in programming (see at page 15).

Pag. 28

Pag. 5