Cleaning the filters
Caution! Do not use the appliance without the filters. Make sure that the installation of the filters is correct. Incorrect installation will cause unsatisfactory washing results and damage to the appliance.
If necessary, clean the filters. Dirty filters de- crease the washing results.
The dishwasher has three filters:
1.coarse filter (A)
2.microfilter (B)
3.flat filter (C)
A 
B 
C 
Do these steps to clean the filters:
1.Open the door.
2.Remove the lower basket.
3.To unlock the filter system, turn the han- dle on the microfilter (B) approximately 1/4 anticlockwise.
4.Remove the filter system.
5.Hold the coarse filter (A) by the handle with the hole.
6.Remove the coarse filter (A) from the mi- crofilter (B).
7.Remove the flat filter (C) from the bottom of the appliance.
electrolux 13
D
8.Clean the filters below running water.
9.Put the flat filter (C) in the bottom of the appliance. Install the flat filter correctly under the two guide (D).
10.Put the coarse filter (A) in the microfilter
(B) and push the filters together.
11.Put the filter system in position.
12.To lock the filter system, turn the handle on the microfilter (B) clockwise until it lock in position.
13.Install the lower basket.
14.Close the door.
Do not remove the spray arms.
If the holes in the spray arms become clog- ged, remove remaining parts of soil with a cocktail stick.
External cleaning
Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only use neutral detergents. Do not use abrasive products, scouring pads or solvents (acetone, trichloroethylene etc...).