Epson ESL63010 Technical data, Installation, Attaching the appliance to the adjacent units

		electrolux 15
The cleaning results are not satisfactory
The dishes are not clean	• The selected washing programme is not applicable for the type of
		load and soil.
	• The baskets are loaded incorrectly so that water cannot reach all
		surfaces.
	• Spray arms do not turn freely because of incorrect arrangement of
		the load.
	•	The filters are dirty or not correctly installed.
	•	The quantity of detergent is too little or missing.
Limescales particles on the	•	The salt container is empty.
dishes	• The water softener is adjusted on a wrong level.
	•	The salt container cap is not closed correctly.
The dishes are wet and dull	• No rinse aid has been used.
	• The rinse aid dispenser is empty.
There are streaks, milky spots	• Decrease the rinse aid dosage.
or a bluish coating on glasses
and dishes
Dry water drop signs on	• Increase rinse aid dosage.
glasses and dishes	• The detergent can be the cause.

Technical data

Dimensions

Electrical connection - Voltage - Overall power - Fuse

Water supply pressure

Capacity

Width cm	59,6
Height cm	81,8-87,8
Depth cm	55,5

Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door.

Minimum	0,5 bar (0,05	MPa)
Maximum	8 bar (0,8	MPa)
Place settings		12

Installation

Warning! Make sure that mains plug is disconnected from the mains socket during installation.

Important! Obey the instructions in the enclosed template to:

•Build-in the appliance.

•Install the furniture panel.

•Connect to the water supply and drain.

Install the appliance under a counter (kitchen worktop or sink).

If a repair is necessary, the appliance must be easily accessible for the engineer.

Put the appliance adjacent to a water tap and a drain.

For the venting of the dishwasher only water fill, water drain and power supply cable open- ings are necessary.

The dishwasher has adjustable feet to allow the adjustment of the height.

Make sure that the water inlet hose, the drain hose and the supply cable are not kinked or squashed, when you insert the machine.

Attaching the appliance to the adjacent units

Make sure that the counter below which you attach the appliance is a safe structure (ad- jacent kitchen units, cabinets, wall).

Adjusting the level of the appliance

Make sure that the appliance is level to close and seal the door correctly. If the level of the