electrolux 11
3.Do a washing programme without dishes.
4.Adjust the water softener to the water hardness in your area.
5. Adjust the rinse aid dosage.
Setting and starting a washing programme
Set the washing programme with the door ajar. The washing programme only starts after you close the door. Until then it is possible to modify the settings.
Do these steps to set and start a washing programme:
1.Switch on the appliance.
2.Make sure that the appliance is in setting mode.
3.Press the programme selection/cancel button again and again to set the washing programme. Refer to the chapter 'Wash- ing programmes'.
–The programme indicator light comes on.
4.Close the door.
–The washing programme starts auto- matically.
When the washing programme oper- ates, you cannot change the pro- gramme. Cancel the washing pro- gramme.
Warning! Only interrupt or cancel a washing programme if necessary.
Caution! Open the door carefully. Hot steam can come free.
Cancelling a washing programme
1.Press and hold the programme selection/ cancel button for approximately 3 sec- onds.
–The programme indicator light goes off.
–The end indicator light starts to flash.
2.Release the programme selection/cancel button to cancel the washing pro-
gramme.
At this time you can do these steps:
1.Switch off the appliance.
2.Set a new washing programme.
Fill the detergent dispenser with detergent before you set a new washing programme.
Interrupting a washing programme
Open the door.
•The programme stops. Close the door.
•The programme continues from the point of interruption.
Setting and starting a washing programme with delay start
1.Press the on/off button.
2.Set a washing programme.
–The programme indicator light comes on.
3.Press the delay start button.
–The delay start indicator light comes on.
4.Close the door.
–The countdown of the delay start starts.
–When the countdown is completed, the washing programme starts auto- matically.
Do not open the door during the count- down to prevent interruption of the countdown. When you close the door again, the countdown continues from the point of interruption.
Cancelling a delay start:
1.Open the door.
2.Press the delay start button.
–The delay start indicator light goes off.
3.Close the door.
–The programme starts immediately.
End of the washing programme
Switch off the appliance in these conditions:
•The appliance stops automatically.
•The audible signals for the end of the pro- gramme operate.
1.Open the door.
–The end indicator light comes on.
–The programme indicator light stays on.
2.Press the on/off button.