6electrolux
Water hardness
Water hardness setting
°dH |
| °TH |
| mmol/l | Clarke |
37 - 42 |
| 65 - 75 |
| 6,5 - 7,5 | 46 - 52 |
29 - 36 |
| 51 - 64 |
| 5,1 - 6,4 | 36 - 45 |
23 - 28 |
| 40 - 50 |
| 4,0 - 5,0 | 28 - 35 |
19 - 22 |
| 33 - 39 |
| 3,3 - 3,9 | 23 - 27 |
15 - 18 |
| 26 - 32 |
| 2,6 - 3,2 | 18 - 22 |
11 - 14 |
| 19 - 25 |
| 1,9 - 2,5 | 13 - 17 |
4 - 10 |
| 7 - 18 |
| 0,7 - 1,8 | 5 - 12 |
< 4 |
| < 7 |
| < 0,7 | < 5 |
|
|
|
|
|
|
1) No use of salt required.
manually
2
2
2
2
1
1
1
11)
electronically
8
7
6
5
4
3
2
11)
You must set the water softener man- ually and electronically.
Manual adjustment
The appliance is set at the factory at po- sition 2.
1.Open the door.
2.Remove the lower basket.
3.Turn the water hardness dial to position 1 or 2 (refer to the chart).
4.Install the lower basket.
5. Close the door.
Electronic adjustment
The water softener is set at the factory at level 5.
1.Switch on the appliance.
2.Make sure that the appliance is in setting mode.
3.Press and hold the programme selection/ cancel button.
4.Release the programme selection/cancel button when programme indicator light A starts to flash and programme indicator light B comes on.
5.Wait until programme indicator light B goes off.
–Programme indicator light A starts to flash.
–The end indicator light starts to flash.
6.Press the programme selection/cancel button one time.
–Programme indicator light A starts to flash.
–The setting function of the water soft- ener is activated.
–The end indicator light flashes to show the level of the water softener. Example: 5 flashes, pause, 5 flashes, pause, etc... = level 5.
7.Press the programme selection/cancel button one time to increase the water softener level by one step.
8.Press the on/off button to save the oper- ation.
Use of dishwasher salt
Caution! Only use dishwashers salt. Types of salt that are not applicable for dishwashers cause damage to the water softener.
Caution! Grains of salt and salty water on the bottom of the appliance can cause corrosion. Fill the appliance with
salt before you start a washing programme to prevent corrosion.
Do these steps to fill the salt container:
1.Turn the cap anticlockwise to open the salt container.
2.Fill the salt container with 1 litre of water (only the first operation).