Vanguard Heating SBVRBP Cast Iron Stove and B-VENT Burner System Assembly, Stove Body Assembly

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY

STOVE BODY ASSEMBLY

1.Lift off corrugated box enclosing stove body crating.

2.Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from plastic-bagged stove body. The bottom pieces of pallet wood will remain bolted to the stove body.

3.Remove plastic bag from stove body.

4.Remove back panel from stove and dis- card (see Figure 6). Use an adjustable wrench or a 10 mm socket. Remove six

(6)bolts and washers. Keep bolts and washers to reattach rear cover.

5.Remove all contents from inside stove cavity. Contents include:

(1)- Stove bottom (Discard - Not used with this application)

(4)- Legs with leg leveler bolts

(1)- Bottom door

(3)- Top grates

(1)- Hardware kit bag with fasteners

6.Carefully lay stove body on back to at- tach bottom components to stove body (see Figure 7). Rest stove on drop cloth or blanket to avoid scratching stove edges.

7.Remove remaining pallet wood at- tached to bottom of stove body (see Figure 8). Use an adjustable wrench to remove bolts.

8.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 9 and Figure 10 on page 6). Use an adjustable wrench or a 12mm socket.

Figure 8 - Removing Pallet Wood From The Bottom of The Stove

Leg Hole

Leg Hole

Bottom Of

Stove Unit

Figure 9 - Locating Threaded Holes for Legs and Door Attachment

Continued