Disassembly

IMPORTANT: Before disassembling the unit make sure you turn the power OFF and unplug the machine from the electrical outlet.

STEP 1:

Pusher

Chute

STEP 2:

Locking

Bar

Remove pusher from the chute.

Lower the locking bar (silver) into position as shown.

Pulp

Collector

STEP 3:

Lid with built-in Pulp Guard

Receptacle

STEP 4:

Lip

Pulp Collector Base

Remove lid with built-in pulp guard by pulling up off of receptacle.

Remove pulp collector by sliding the bottom away from the base in the direction of the arrows while unhooking from under lip on receptacle.

Receptacle

Lift and Twist......

Base

STEP 5:

Remove filter/blade/receptacle unit from base by grasping the receptacle with two hands. Then lift receptacle and twist in either a clockwise or counter-clockwise direction while pulling in an upward direction until filter/blade/receptacle unit is separated from the main base.

Note: Do not remove screws from blade. The filter and the blade are one piece. They are not meant to be separated.