Jack Lananne's Power Juicer PPJJEE VV22 manual Assembly, Assemble as shown

ASSEMBLY						Assemble as shown
STEP 1:
					1
Place base on a dry flat surface with locking
bar in down position as shown. In front
of the machine (spout side).									Locking
IMPORTANT: There is a safety MicroSwitch
					Base				Bar
located in the track of the left side of the
Machine (opposite side of power switch).
This mechanism is an added
safety feature. Once the pulp
collector is in place it activates
the safety MicroSwitch. This will
protect you from accidentally
putting hands or fingers under							Front of Machine
the machine while the blade is
							(Spout side)
turning. Once the pulp collector
is removed from the main base
		Safety MicroSwitch
the motor will not run.
STEP 2:
					Pulp
Align grooves on the bottom of pulp collector					Collector
with tracks on the base. Note: This is where
							2
the Safety MicroSwitch is located. Slide
pulp collector towards base in the directions									Base
of the arrows. Make
sure pulp collector				Base
is firmly in place
against the base.
IMPORTANT:
The motor will not run
if pulp collector is not
properly assembled.
Pulp Collector
STEP 3:	(Bottom)
		Base	(Tracks)
				3			Receptacle
Place receptacle on the base, with juicer
spout facing direction of locking bar.
Settle receptacle into alignment.
								Juice Spout
								Base
									Locking
									Bar

6