Vita-Mix BarBos MP owner manual BarBoss MP Drink Machine MP Model

OFF

ON

Note on Timers: Stop mid cycle with START/STOP switch, not the ON/OFF switch. If the ON/OFF switch was used, wait 30 seconds for power to recycle and the timer to reset before resuming operation.

#4	#5
	Max

#3

#2

#1

PULSE

START/STOP

TIMER

BarBoss® MP &

Drink Machine MP Model

ON/OFF switch. Located on the front of the machine below the switch panel, controls the power to the machine. With the machine plugged in, switch the machine to ON to ready the machine for blending. Shut OFF power switch at night or whenever the machine will be left unattended.

START TIMER switch. This is a lighted switch. When light is lit power is ON. Depress START TIMER switch to activate timer setting and again to stop midcycle.

During operation, you may interrupt timer by pressing START/STOP switch.

TIMER DIAL. Allows user to select a number of timed settings. Increments on timer are approximate seconds. Timer is activated only when the power switch is ON. Blender will shut off automatically at the end of the pre-set time.

PULSE switch. Pulse button can only be used when the power switch is ON. The PULSE switch can be used to quickly refresh product in the container by depressing the switch and holding down as long as needed.

NOTE: Switches will become sticky from use. Use a wet cloth or sponge to flush and clean in the groove around the water-shielded switches. You may also lightly spray the surface around the switches with an all purpose cleaner (such as Cinch® or 409®) and work the switches back and forth a few times to loosen any dried residue under switch. Leaving switches sticky will damage or burn out the switches.

4