Motor Base
1.Unplug the power cord.
2.Wash outside surface with a damp, soft cloth or sponge, which has been rinsed in a mild solution of liquid dish soap (Ivory Liquid® or equivalent) in warm water. NEVER IMMERSE MOTOR BASE IN WATER OR OTHER LIQUID.
3.Thoroughly clean switches so that they work freely. They will become sticky from use. Use a wet cloth or sponge* to flush and clean in the groove around the water shielded switches. You may also lightly spray the surface around the switches with an
4.Polish with a soft cloth.
*Note: Be sure to wring excess water out of cloth or sponge when cleaning around the controls or any electrical part.
Lid
Separate the lid and plug, then wash in warm soapy water. Rinse clean under running water and dry. Reassemble before use. (See page 5).
Container
1.To clean: Fill pitcher 1/4 full with warm (110˚F/43˚C) water and add a couple drops of dish soap.** Return container to motor base and firmly position the two part lid. Run machine for 30 seconds. Empty container. Repeat this step.
**Note: To prolong polycarbonate container life,
2.Fill pitcher 3/4 full with warm (110˚F/43˚C) water (do not add soap). Return container to motor base and firmly position the two part lid. Run machine for 30 seconds. Empty container.
3.If any solid residue remains, remove the blade agitator assembly (see page 8) and wash all container parts in warm soapy water. Rinse and drain. Reassemble before next step.
4.To sanitize: If all solid residue is gone after step 2 or after completion of step 3,
fill container 3/4 full with a sanitizing solution mix.*** Return container to motor base and firmly position the two part lid. Run machine on HIGH for 30 seconds. Empty container.
5.Return container to motor base and run machine empty for an additional 5 seconds. Do not rinse after sanitizing.
***Recommended sanitizing solution:
11