Kenmore 790.9751 manual Before Setting Surface Controls cont’d, To Set the Cooktop Lockout Feature

Before Setting Surface Controls (cont’d)

To Set the Cooktop Lockout Feature

The COOKTOP LOCKOUT pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being accidentally turned ON. This feature will only lock the cooktop.

Instructions PRESS

DISPLAY

To turn the Cooktop Lockout Feature ON:

1.BE SURE ALL surface element controls are set to the OFF position.

2.Press and hold for 3 seconds COOKTOP LOCKOUT until two appears in the display (Figure 1). If a triple beep sounds instead, check all surface elements and turn them to the OFF position and repeat

this step. The two will appear in the display indicating the cooktop controls and functions are locked out until the cooktop is unlocked. Whenever the Cooktop Lockout feature is active, “ - -” will appear in all of the surface element display windows.

To turn the Cooktop Lockout Feature OFF:

1.Press and hold for 3 seconds COOKTOP LOCKOUT until the two disappears from the display (Figure 2). This will indicate the cooktop

may be used normally.

Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop Lockout feature. The cooktop will remain locked until the Self-Clean cycle has completed and the oven door has unlocked.

Note: If a power failure occurs after the Cooktop Lockout has been activated, you must turn OFF the Cooktop Lockout feature before being able to use the cooktop features again.

for 3 seconds

for 3 seconds

Figure 1

Figure 2

8