Kenmore 790.9751 Operating the Triple Surface Element, To Operate the Triple Surface Element

Page 11

Setting Surface Controls (cont’d)

Operating the Triple Surface Element

The cooktop is equipped with a Triple radiant surface element

located at the right front cooktop position (Figure 1). Indicator

lights on the control panel at that position are used to indicate

what portions of the Triple radiant element will heat. The

light indicates that only the inner element will heat. The

light indicates that both inner and middle elements will heat

together. The

light indicates that all 3 portions of the

element will heat. You may switch between all of these different

Figure 1

Figure 2

settings at any time during cooking.

 

 

 

To Operate the Triple Surface Element:

1. Place correctly sized cookware on the radiant surface element.

2. Touch and hold the pad for the Triple element position until a beep is heard. The display will show “ - - ”.

Note: If no further pads are touched within 10 seconds the

 

request to power the element ON will clear.

Figure 3

3.Select the (See Figure 2), (See Figure 3) or elements (See Figure

4) to heat by pressing the pad once, twice or three times (Figures 4 show indicator lights with ALL 3 elements selected).

4.Touch Hi pad once to turn ON the power level to HI (See Figure 5). Touch Lo pad once for Lo.

5.Each touch of the Hi or Lo pad will decrease or increase the power level from 9.0 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest power level available.

Note: The power level may be adjusted at any time while the element is ON.

Each surface element provides a constant amount of heat at each setting.

Irregular glowing effect is depending of the element design and doesn’t affect performance of the element. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

6.When cooking has been completed touch the pad once to turn the element OFF.

Note: If no element size is chosen when the Triple element is turned ON, the control will default to the inner coil only. See recommended surface cooking settings.

Note: The Hot Surface message will be displayed on the control panel as soon as the element is hot and will remain ON until the heating surface area has cooled sufficiently.

Figure 4

Figure 5

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if

placed too close to the surface elements.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Kenmore Elite Table of Contents Do not use the ovens for storage Death or property damageProperty damage To reduce the risk of tipping,Important Instructions for Using Your Cooktop Save these instructions for future reference 18 19 2122 Range FeaturesYour Range includes Locations of the Radiant Surface Elements and Controls About the Ceramic Glass CooktopAbout the Radiant Surface Elements Display Before Setting Surface Controls cont’dTo Set the Cooktop Lockout Feature InstructionsSetting Surface Controls Single Elements Setting Surface Controls cont’dOperating Single Radiant Surface Elements To Operate the Single Radiant Surface ElementsLight indicates that only the inner element will heat. Operating the Triple Surface ElementTo Operate the Triple Surface Element What portions of the Triple radiant element will heat.Food Item Warmer Zone Settings TableWarmer Zone Temperature Selection Operating the Warmer Warm & Ready ZoneCookware Material types Before Setting the Oven ControlsSurface Cooking Selecting Surface Cooking CookwareFlat Oven Vent LocationRemoving & Replacing Oven Racks Arranging Oven Racks & SupportsFollow later in this Use & Care Guide Feature Min. Temp. or timeOven Control Keypads To set the clock example below for Setting the ClockSetting the Clock Press DisplayTo set the Kitchen Timer example 5 minutes Setting Continuous Bake or 12 Hour Energy SavingSetting Kitchen Timer To Set Add 1 Minute FeatureConsumer Defined Control Setting Oven Lockout FeatureSetting Silent Control Operation To activate the Oven Lockout featureOperating Oven Lights Setting Temperature Display Fahrenheit or CelsiusSetting Accent Light Example To adjust the Accent light brightnessTo set the Preheat temperature for 350F Setting Oven ControlsSetting Preheat Arrange interior oven racks and place food in oven Press Temperature Visual DisplaySetting Bake To set the Bake Temperature to 350FOven Baking Baking Problems and Solutions ChartInstructionsPRESSDISPLAY Setting Cook TimeWhen the timed bake finishes When the set bake time runs out Setting Delay StartBroiling Table Recommendations Setting BroilBroiling Times and Searing Grill if equipped To set the oven to broil at 550FRoasting Rack Instructions if equipped Setting the Food Categories FeaturesExample To Set the Cakes or Breads features Benefits of Convection BakeGeneral Convection Bake Instructions Setting Convection BakeTo set the oven for Convection Bake and temperature to 350F Press to cancel Convection feature at any time Setting Convection Convert featureSetting the Slow Cook Feature To set Warm & Hold to turn on automatically Setting the Warm & Hold FeatureTo set Warm & Hold To 550F and then press To Program the Oven to Begin Baking with a stored Recipe To Set the Recipe Recall FeatureRestoring factory default settings Recipe example for a Bake mode at 425CDo Hand Self-Cleaning OvenAdhere to the following cleaning precautions Withstand high cleaning temperaturesTo start an immediate Self-Cleaning cycle or to set a Delay Self-CleaningTo Start the Self-Clean Cycle When the Self-Clean Cycle is CompletedTo adjust the oven temperature Self CleaningAdjusting Oven Temperature Stopping or Interrupting a Self-Cleaning CycleDecorative Trim Surfaces How to Clean Aluminum Trim PiecesVinyl Panel, Body Parts,Cleaning Recommendations for the Ceramic Glass Cooktop Ceramic Glass Cooktop Cleaning & MaintenanceTo Replace Oven Door Removing and Replacing the Lift-Off Oven DoorChanging the Halogen Oven Light To Remove Oven DoorOccurrence Possible CAUSE/SOLUTION Brown streaks or specks Scratches or abrasions onCooktop surface MetalmarksOccurrence Page Protection Agreements MY-HOME1-800-469-4663 Sears Parts & Repair Service CenterSU-HOGAR

790.9751 specifications

The Kenmore 790.9751 is a sophisticated and versatile range that embodies a blend of modern technology and user-friendly design, making it an ideal choice for any kitchen space. One of its standout features is the powerful gas cooktop, which offers five burners varying in size and output. This allows for efficient multitasking, whether you’re simmering sauces or boiling pasta. The high-output burner is specifically designed to provide intense heat for rapid cooking, while the low-simmer burner is perfect for delicate tasks.

One of the key technologies integrated into the Kenmore 790.9751 is its True Convection oven. This feature circulates hot air throughout the oven cavity, ensuring even temperature distribution. As a result, dishes cook more uniformly, reducing baking times and increasing overall cooking efficiency. This convection technology is particularly beneficial for baking cookies, roasting meats, or creating perfectly risen soufflés.

The oven also boasts a generous capacity, offering ample space for baking multiple dishes at once or accommodating larger items like turkeys, making it a practical option for families or those who enjoy entertaining. Another noteworthy characteristic is its self-cleaning function, which simplifies maintenance. With this feature, the oven heats to a high temperature to burn off food residue, allowing for easy cleanup without the need for harsh chemicals.

The Kenmore 790.9751 is designed with user convenience in mind, featuring an intuitive control panel that includes a digital display for easy temperature adjustments and timer settings. The oven's additional features like broil mode, delay bake, and multiple cooking settings further enhance its usability.

In terms of aesthetics, the sleek stainless steel finish not only contributes to its modern look but also provides durability and resistance to smudges, making it easy to maintain its stylish appearance. Safety is also a priority, as evidenced by features like auto shut-off and a child lock option.

Overall, the Kenmore 790.9751 combines advanced cooking technologies with thoughtful design elements, ensuring it meets the diverse needs of today’s home chefs. Its blend of efficiency, ease of use, and aesthetic appeal makes it a strong contender in the world of kitchen appliances. Whether you are a novice cook or a seasoned chef, this range is equipped to enhance your culinary adventures.
Top Page Image Contents