Kenmore 790.75602 To Remove and Replace Oven Door, To Remove Oven Door, To Replace Oven Door

Page 20

Care & Cleaning

Cleaning the Contoured Well Areas, Burner Cap and Burner Head

The contoured well areas, burner cap and burner head should be routinely cleaned. Keeping the burner ports clean willprevent improper ignition and an uneven flame. Refer to the following instructions:

Surface

BurRer

E--

To Clean the Recessed and Contoured Areas of the Cooktop- Ira spill occurs on or in the recessed orcontoured areas, blot up spill with an absorbentcloth. Rinse with a clean, damp cloth and wipe dry.

To Remove and Replace the Surface Burner Caps and Surface Burner Heads - Remove in the following order: (1st) surface burner grate, (2nd) surface burner cap, (3rd) surface burner head.

Reverse the procedure above to replace the surface burner cap and surface burner head. Do not remove any parts from the cooktop until they have completely cooled and are safe to handle. Do not operate the surface burners without the surface burner cap and surface burner head properly in place.

Surface

_

Burner

 

Head

_rlflce

Holder,

To Clean the Surface Burner Cap and Surface Burner Head - Use a soap-filled scouring pad or a mild abrasive cleanser to clean the surface burner caps and surface burner heads. The ports (or slots) around the burner head must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes. For proper flow of gas and ignition of the burner--DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS keep the surface burner cap and surface burner head in place whenever a surface burner is in use.

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

Use caution when replacing the burner cap so the electrode is not damaged. This may ca use a delayed ignition

or prevent the burner from igniting.

Any

additions,

changes or conversions

required in order for this appliance to perform satisfactorily must be /

made by an author

zed Sears

Serv ce Center.

J

To Remove and Replace Oven Door

To Remove Oven Door:

1.Open the door.

2.Remove screws located on the inside of the oven door near the hinges A (one on each side.)

3.Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off the hinges.

4.To clean oven door, follow the instructions provided in the Care & Cleaning table.

To Replace Oven Door:

1.Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges open by hand. The hinges may snap back against the oven frame and could pinch fingers.

2.Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the door.

3.Hinge arms must go into the range slots evenly. The hinge arms should be inserted into the bottom corners of the door as far as they can go.

4.If the door is not in line with the oven frame, remove it and repeat the above steps.

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents GAS Range Full ONE Year Warranty on ALL Parts Sears Maintenance AgreementsSears Maintenance Agreement 790Important Safety Instructions For Your SafetySelf Cleaning Ovens Important Instructions for Using Your CooktopImportant Instructions for Cleaning Your Range Serial Plate Location Important Safety NoticeGrounding Instructions Range Features YourOperating the Gas Surface Burners Setting Surface ControlsSetting Proper Surface Burner Flame Size Before Setting Oven Controls Oven Vent LocationArranging Oven Racks Removing & Replacing Oven RacksOven Control Functions ConversionSetting Oven Controls To Change the Minute Timer while it is in useTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingConvection Cooking General Convection Cooking InstructionsTo Set Convection Cooking Air circulation duringTo Set the Timed Bake Feature To Program Oven for a DelayedWhen the Set Bake Time Runs Out Control will beep 3 times every 60 seconds untilTo Broil Rack Position From Top Food Rare steaksSetting Warmer Drawer Controls Warmer Warm & Ready TM Drawer Temperature SelectionWarmer Drawer Recommended Food Settings Chart Food Item Warm & Ready TM DrawerTo Replace Warmer Warm & Ready TM Drawer To Remove and Replace Warmer Warm & Ready TM DrawerTo Remove Warmer Drawer Adhere to the following cleaning precautions Self-CleaningSelf-Cleaning Stopping or Interrupting a Self-Cleaning Cycle To Start the Self-Clean CycleTo Set the Controls for a Self-Clean Cycle When the Self-Clean Cycle is CompletedCare & Cleaning How to CleanCleaning the Cooktop SurfacesTo Replace Oven Door To Remove and Replace Oven DoorTo Remove Oven Door Adjusting Your Oven Temperature Care and Cleaning of Stainless Steel some modelsWire Holder To Adjust Oven TemperatureOccurrence Possible CAUSE/SOLUTION Before You CallPossible CAUSE/SOLUTION OccurrenceAu Canada pourservice en frane,,ais PART6 a.m. 11 p.m. CST, 7 days a week A. onlyLE-FOYER ic SU-HOGAR si

790.75602, 790.75609, 790.75604 specifications

The Kenmore 790 series, particularly models 790.75604, 790.75609, and 790.75602, are designed to cater to the needs of modern home cooks. These gas ranges provide a perfect blend of functionality, style, and advanced technology to enhance the cooking experience.

One of the standout features of the Kenmore 790 series is its powerful cooktop. Each model is equipped with multiple burners that vary in output, providing versatility for different cooking techniques. From simmering delicate sauces to boiling water quickly, the range offers a variety of burner sizes that cater to all your culinary needs. The high output burners are ideal for searing meats while the lower output burners allow for precise simmering, making it easier to control the heat.

The oven is another highlight of these models. The convection technology ensures that heat circulates evenly, cooking food more consistently and reducing cooking times. For those who enjoy baking, this feature can make a noticeable difference, yielding perfectly risen cakes and evenly baked pastries. The oven also comes with a self-cleaning function, making maintenance a breeze.

In terms of design, the Kenmore 790 series boasts a sleek, stainless steel finish that complements any kitchen décor. The controls are conveniently located at the front, making it easy to adjust the heat settings without reaching over hot surfaces. The range is also equipped with a large viewing window and interior lighting, allowing users to monitor their cooking progress without opening the oven door.

Safety is another priority for the Kenmore 790 series. These models include an electronic ignition system, which ensures that the burners ignite quickly and safely. Additionally, features such as the oven lock and auto shut-off give users peace of mind, knowing that their appliances will perform safely.

The Kenmore 790 models come with a range of additional features, including a broiler drawer for added versatility and easy-to-clean surfaces that make maintenance simpler. The combination of innovative technology, practical features, and stylish design makes the Kenmore 790.75604, 790.75609, and 790.75602 models excellent choices for both novice and experienced home chefs. With these ranges, cooking becomes not just a task, but an enjoyable and rewarding experience.
Top Page Image Contents