Kenmore 790.75604 manual Adjusting Your Oven Temperature, Changing the Oven Light, Wire Holder

Page 21

Care & Cleaning

Oven

Light

Wire

Holder

Changing the Oven Light

On some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use. To replace the oven light:

1.Turn electrical power off at the main source or unplug the range.

2.Press wire holder to one side to release the glass shield.

3.Replace bulb with a new 40 watt appliance bulb.

4.Replace glass shield over bulb and snap wire holder into place.

5.Turn power back on again at the main source (or plug the range back in).

6.The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Guide.

_r _ Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

Care and Cleaning of Stainless Steel (some models)

b"

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the G© appearance of stainless parts. Refer to the Care & Cleaning table for detailed cleaning instructions.

Adjusting Your Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from you rprevious oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press

2.Set the temperature to 550°F (287°C) by pressing and holding the A .

3. Within 2 seconds, press and hold _ until the 2 digit display appears. Release _. The display now indicates the

amount of degrees offset between the original factory temperature setting and the current temperature setting. Ifthe oven control has the original factory calibration, the display will read "0."

4.The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the A or v .

Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5. When you have made the desired adjustment, press _ to go back to the time of day display.

Note: The adjustments made will not change the self-cleaning temperature.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents GAS Range Sears Maintenance Agreements Full ONE Year Warranty on ALL PartsSears Maintenance Agreement 790For Your Safety Important Safety InstructionsImportant Instructions for Using Your Cooktop Important Instructions for Cleaning Your RangeSelf Cleaning Ovens Important Safety Notice Grounding InstructionsSerial Plate Location Your Range FeaturesSetting Surface Controls Setting Proper Surface Burner Flame SizeOperating the Gas Surface Burners Oven Vent Location Before Setting Oven ControlsArranging Oven Racks Removing & Replacing Oven RacksConversion Oven Control FunctionsTo Change the Minute Timer while it is in use Setting Oven ControlsTo Set Control for Continuous Bake or 12 Hour Energy Saving To Set or Change the Temperature for BakingGeneral Convection Cooking Instructions Convection CookingTo Set Convection Cooking Air circulation duringTo Program Oven for a Delayed To Set the Timed Bake FeatureWhen the Set Bake Time Runs Out Control will beep 3 times every 60 seconds untilRack Position From Top Food Rare steaks To BroilWarmer Warm & Ready TM Drawer Temperature Selection Setting Warmer Drawer ControlsWarmer Drawer Recommended Food Settings Chart Food Item Warm & Ready TM DrawerTo Remove and Replace Warmer Warm & Ready TM Drawer To Remove Warmer DrawerTo Replace Warmer Warm & Ready TM Drawer Self-Cleaning Self-CleaningAdhere to the following cleaning precautions To Start the Self-Clean Cycle Stopping or Interrupting a Self-Cleaning Cycle To Set the Controls for a Self-Clean Cycle When the Self-Clean Cycle is CompletedHow to Clean Care & CleaningCleaning the Cooktop SurfacesTo Remove and Replace Oven Door To Remove Oven DoorTo Replace Oven Door Care and Cleaning of Stainless Steel some models Adjusting Your Oven TemperatureWire Holder To Adjust Oven TemperatureBefore You Call Occurrence Possible CAUSE/SOLUTIONOccurrence Possible CAUSE/SOLUTIONPART6 a.m. 11 p.m. CST, 7 days a week A. only Au Canada pourservice en frane,,aisLE-FOYER ic SU-HOGAR si
Top Page Image Contents