Kenmore 790.3107, 790.3106 manual Setting the Dual Ring Burner, Large Coakware Operation Zone a & B

Setting Surface Controls

Setting the Dual Ring Burner

The Dual Ring Burner has two rings of flame that you can control for two different heat levels, one for small and one for large cookware.

Large Coakware Operation (Figure 1; Zone A & B)

1.Place a large cooking utensil centered over the dual surface Burner Grate.

2.Push the surface control knob down and turn

counferclockwlse out of the OFF position.

3.Release the knob and rotate to the LITE position (Figures 2 & 3).

4.Vlsually check that the burner has llt.

5.When the burner is lit,

continue	to turn the				Figure 2
control knob		counferclockwlse		between the HI position
and the	MED	position	to adjust to the		desired flame
size for	both	burners	together	(Figure	1).
Simmering	Operation		(Figure	1; Zone A)

1.Place a small cooking utensil centered over the dual surface Burner Grate.

2.Push the surface control knob in and turn

counferclockwlse out of the OFF position (Fig. 2 & 3).

3.Release the knob and rotate to the UTE position.

4.Vlsuaffy check that zone A & B of dual burner has llt.

5.Continue to turn the gas control knob counterclockwise past the MED position; zone B will turn off. Adjust the simmer flame size by turning the control knob between the MED position to the LO position.

important notes:

°DO NOT cook with the surface control knob left in the LITE position. (The electronic ignitor wiii continue to spark if the control knob setting remains in the LITE position).

°When setting any surface control knob to the LITE position° aii electronic surface ignitors wiii spark at the same time. However° only the surface burner you are setting wiii ignite.

°NFVl:R place or straddle a cooking utensil aver two different surface cooking areas at the same time. This can cause uneven heating results.

Figure 1

DUAL RING BURNER

OFF

LITE

Figure 3

Figure 4

13