RE OVAL OF PACKAGBNG TAPE:
k
When packaging tape is removed from new appliances, a residue Is sometimes left on t_ie appliance. The safest way to remove this adhesive, and prevent damageto the product finish, is by using an application of household liquid dish washing detergent, mineral o1!,or cooking oil. Apply with soft cloth and allow to soak. Wipe with soft cloth. DO NOT use plastic pad or equivalent. Wipe dry and then apply an appliance polish to thoroughly clean and protect the surface, This procedure is also safe for the face of microwave doors and other plastic and lexan parts.
NOTE: The plastic tape that is not removed from chrome trim on range parts CANNOT be removed if baked on.
t
MICROWAVE OVEN LAMP
To replace:
1.Disconnect power at main fuse or circuit breaker panel.
2o Open microwave oven door, then remove the two Phlllips head screws from the bottom of the grille. Remove the grille,
rl..., | iii | i1,,i.... | iii | i i | i, | i, ii | jjl,lll | /.." | H |
4.Remove the tape around the base of the IlghL The tape Is there to prevent the light from loosening during shipment and door closings. Removing the tape may be difficult.
5.Unscrew the bulb carefully. Use a cloth to protect your hands In case the glass breaks.
NOTE: The light is not standard. Replace it wi_h a similar 125 volt, 20 Watt bulb,
6. Screw replacement bulb lnto socket and replace llght cover and grille. Reconnect power to cooking center.
3.Remove the light cover by removing the two Phillips head screws.
MICROWAVE SHELF ACCESSORY
To position the Microwave Oven shelf, tip the back s!lg htly and fit the shelf support guides onto the support guides located on each side of the oven in the rear.
Next, lower the front until the shelf support guides fit onto the support guides located at each slde of the oven In the front.
When properly positioned, the shelf should fit snugly In place, be level and not touch the back wall of the oven.
NOTE: If electrical arcing occurs when using the shelf to cook more than one food at the same timer turn the oven off. Make sure the shelf is positioned
29 | NEMNTt |