Omega Vehicle Security zSeries ACCESS CONTROL

4.2 Setting a New IP Address over the Network

Besides using the iConnect software, you may use the Coordinator’s default IP address

to access it and assign a new IP address to it.

The Coordinator is shipped with a default IP address of 192.168.1.200 and Subnet Mask of

255.255.255.0. You can configure your PC’s Network connection with an IP address that

is in the same range as the Coordinator’s IP address (192.168.1.x) and connect to the

Coordinator using a crossover network cable between your PC and the Coordinator.

With this completed, you can go to the DOS-Prompt and ping 192.168.1.200. If you

receive responses back (Figure 4.1), you can go to the Web browser and type in

http://192.168.1.200 and it will take you to the zSeries Home Page.

Select

button, you’ll be asked for the password. You should be on the

Access Control page were you can simply type in the desired Static IP address, and click

Save.

For more details about the “Access Control” page refer to Section 4.3.9.

Figure 4.4 Access Control

For the IP address to take effect, the Coordinator needs to be turned OFF and ON using

the “Power Recycle” button. Pressing the physical button marked “RESET” on the

Coordinator does the same thing.

You can now connect the Coordinator to an Ethernet hub using a straight through cable,

power it up, and follow the ping routine mentioned in the previous section.

ACCESS CONTROL

ACCESS CONTROL

http://192.168.1.200

Address

Main Menu

Admin Password 00000000

IP Address 192.168.1.200

Gateway Address 0.0.0.0

Subnet Mask 255.255.255.0

MAC Address 00:03:34:00:85:C4

Web Server enable

Host Name z85C4

Save Reset

Power Recycle

Access Control