2.5 Parts of the Coordinator
Figure 2.5 Parts of the Coordinator 
1 Wall mounting bracket clip holes (3 places)
2 Label with model and serial numbers
3 Coordinator’s firmware revision on label
4 8 position DIP switch, from which the last 3 positions are used to assign the NID, network ID number (see Section 2.7 for details)
5 Ethernet: RJ45 interface for
6 Case’s tray, where the PCB is mounted
7 4 position DIP switch, sets the DHCP and Factory Defaults 8 Coordinator’s radio module firmware revision on label
9 Label with default IP address, remove and then write your IP address, in the space provided
10 Label with MAC address (in hex code)
11 Wall mounting bracket
12 Case’s cover mounting screw (2 places)
13 Label for Network address
14 Power supply: Plus (+) power supply wire connection inside the plug; Minus
15 Reset button: Used for power reseting the Ethernet board 16 Case’s cover
8
