4.3.8 Sensor Setup (continued)
SETUP- http://192.168.1.200
SENSOR SETUP
# Check Sensor Name Update Seconds | Units | Power | ||
0 | ABCDEFGH | 10 | - | - |
1 | ABCDEFGH | 10 | - | - |
2 | LAB 100 | 10 | C,mbar Battery | |
3 | ABCDEFGH | 10 | - | - |
4 | ABCDEFGH | 10 | - | - |
5 | ABCDEFGH | 10 | - | - |
6 | ABCDEFGH | 10 | - | - |
7 | ABCDEFGH | 10 | - | - |
Click on Sensor # to modify Sensor Parameters
Firmware
0
0
2.0
0
0
0
0
0
Update Checked Box
Take Readings
View Charts
Select Another Group
Main Menu
| Figure 4.18 Sensor Setup |
#: Sensor ID configured by dip switches on the End Device. Click on the number to view | |
and modify Sensor Parameters. See Figure 4.9. | |
Check: Each check box controls whether or not readings from the End Device will be | |
outputted. If unchecked the readings from the End Device will not be displayed on the | |
“Readings”, “Chart”, and “Diagnostic” pages. Nor it will respond to Telnet connection. | |
Sensor Name: Name of an End Device shows on the “Readings” and “Chart” pages, | |
this is a text field and can take up to 8 alphanumeric characters. | |
Updates Seconds: How often an End Device sends its data to the Coordinator. | |
Units: Type of data and the corresponding units. Units of measurement form sensors | |
inside an End Device that has joined the network will be displayed. [ ºC, ºF or % or | |
mbar, inHg. mmHg ]. |
|
Firmware: Version number of the End Device firmware | |
Update Checked Box: | After checking/unchecking the boxes, make sure this is clicked |
to save the changes. | 35 |
| |
