Kenmore 795.7130-K Crisper Cover with Lattice on Inner, Surface on some models, Modular Door Bins

Page 20

To remove the crisper:

1.Slide crisper straight out to the stop.

2.Lift the front of the crisper, then pull it out to remove.

3.Replace the crisper by sliding it back in fully past the drawer sto ).

To replace lattice on inner surface:

1.For each lattice insert middle tab in 1 (closed to glass cover) and pull sides of the cover to insert lattice.

CRISPER COVER WITH LATTICE ON INNER

SURFACE (on some models)

To remove the crisper cover:

1.Remove both crisper drawers.

2.While holding the crisper cover support (2), pull the cover up and out(l).

[] WARNING: Be careful when handing the glass cover since the glass is not attached to the cover.

To remove the lattice on inner surface:

1.Remove crisper cover (as illustrated above).

2.Hold the glass cover and overturn the crisper cover.

3.For each lattice hold the lattice and pull sides of the cover outward to remove lattice.

MODULAR DOOR BINS

The door bins are removable for easy cleaning and adjusting.

1.To remove the bin, simply lift the bin up and pull straight out.

2.To replace the bin, slide it in above the desired support button and push down until it stops.

[] WARNING: Injury could occur if door bins are not firmly assembled.

NOTE: DO NOT adjust a bin that is loaded with food.

[] CAUTION: DO NOT allow children to play with the baskets. Sharp corners on baskets could cause injury.

NOTE: Do not change the location of the lower bin in the upper doors with the others, or the doors will not close properly.

2O

Image 20

Contents Ill t Models / Modelos / Modeles 795.7130-kParts and Features Refrigerator Installation How to remove Door handle Removing ReplacingCare and Cleaning Freezer SectionOne Year Limited Warranty Disclaimer of implied warranties limitation of remediesMaster Protection Agreements MY-HOMEPage Before YOU Throw Away Your OLD Refrigerator Or Freezer To Connect ElectricityRecommended Grounding Method USE of Extension CordsUsethissectionto becomemorefamiliarwiththepartsandfeatures Installation Base Grille InstallationUnpacking Your Refrigerator EXTAllen Wrench Removing Freezer Drawer Handle Removing Refrigerator HandleMounting Fasteners HOW to Remove Refrigerator Door Removing Refrigerator Door Note Handle appearance may varyLeft Door Right DoorReplacing Refrigerator Door Right Door HOW to Remove and Install the Pull OUT Drawer Removing Pull out DrawerPull OUT Drawer HOW to Remove and InstallInstalling Pull out Drawer Door Alignment Leveling and Door AlignmentLeveling Door Alarm Setting the ControlsEnsuring Proper AIR Circulation MULTI-FLOWAdjusting Control Settings Food Storage GuideStoring Frozen Food To remove a sliding shelf from its metal frame Refrigerator ShelvesSliding Out Shelves optional on some models Pantry On some modelsCrisper Humidity Control on some models Optibin Crispers on some modelsModular Door Bins Crisper Cover with Lattice on InnerSurface on some models Dairy BIN EGG BOX Some modelsDurabase on some models ICE BIN on some modelsGLIDE- OUT Drawer Basket on some models General Cleaning Tips Light Bulb ReplacementOutside Door Liners and GasketsPower Interruptions When YOU GO on VacationWhen YOU Move To change the freezer lightWhen YOU should SET the Icemaker Power Switch to O OFF IcemakerOperation Instructions Normal Sounds YOU MAY HearWhat YOU will Need Power drillBefore YOU Begin Shut OFF the Main Water Supply Connect the Tubing to the Refrigerator Turn the Water on AT the Shut OFF ValvePlug in the Refrigerator Start the ICE MakerUnderstanding Sounds YOU MAY Hear Refrigerator does not OperateVibration or Rattling Noise Check ifCheck if Then Lights do not WorkCompressor Motor Seems to RUN TOO Much Frost or ICE Crystals on Frozen Food Refrigerator Seems to Make TOO Much NoiseCubes Produced by Icemaker are TOO Small Doors are Difficult to Open