Kenmore 795.7130-K manual Replacing Refrigerator Door Right Door

Page 11

2. Replacing Refrigerator Door

•Right Door

•Lower the door onto the middle hinge pin (7).

•Make sure the door is aligned with the cabinet.

•Replace the top hinge (4) installing hinge screws (3) to secure it.

•Make sure the gasket on the door is flush against the cabinet and is not folded.

•Support the door on the handle side while securing. And make sure the door is straight and the gap between the doors is even across the front.

•Install the ground screw (6).

•Connect the door switch wire (2).

•Tighten the cover screw (1).

•Left Door

•Lower the door onto the middle hinge pin (8).

•Make sure the door is aligned with the cabinet.

•Replace the top hinge (4) installing hinge screws (3) to secure it.

•Make sure the gasket on the door is flush against the cabinet and is not folded.

•Support the door on the handle side while securing. And make sure the door is straight

and the gap between the doors is even across the front.

•Connect the door switch wire (2).

•Tighten the cover screw (1).

NOTE: Make sure that the doors seal properly to ensure the refrigerator runs efficiently.

11

Image 11

Contents Models / Modelos / Modeles 795.7130-k Ill tFreezer Section Parts and Features Refrigerator InstallationHow to remove Door handle Removing Replacing Care and CleaningDisclaimer of implied warranties limitation of remedies One Year Limited WarrantyMY-HOME Master Protection AgreementsPage USE of Extension Cords Before YOU Throw Away Your OLD Refrigerator Or FreezerTo Connect Electricity Recommended Grounding MethodUsethissectionto becomemorefamiliarwiththepartsandfeatures EXT InstallationBase Grille Installation Unpacking Your RefrigeratorAllen Wrench Removing Freezer Drawer Handle Removing Refrigerator HandleMounting Fasteners Right Door HOW to Remove Refrigerator DoorRemoving Refrigerator Door Note Handle appearance may vary Left DoorReplacing Refrigerator Door Right Door Removing Pull out Drawer HOW to Remove and Install the Pull OUT DrawerPull OUT Drawer HOW to Remove and InstallInstalling Pull out Drawer Door Alignment Leveling and Door AlignmentLeveling MULTI-FLOW Door AlarmSetting the Controls Ensuring Proper AIR CirculationFood Storage Guide Adjusting Control SettingsStoring Frozen Food To remove a sliding shelf from its metal frame Refrigerator ShelvesSliding Out Shelves optional on some models Optibin Crispers on some models PantryOn some models Crisper Humidity Control on some modelsModular Door Bins Crisper Cover with Lattice on InnerSurface on some models ICE BIN on some models Dairy BINEGG BOX Some models Durabase on some modelsGLIDE- OUT Drawer Basket on some models Door Liners and Gaskets General Cleaning TipsLight Bulb Replacement OutsideTo change the freezer light Power InterruptionsWhen YOU GO on Vacation When YOU MoveNormal Sounds YOU MAY Hear When YOU should SET the Icemaker Power Switch to O OFFIcemaker Operation InstructionsWhat YOU will Need Power drillBefore YOU Begin Shut OFF the Main Water Supply Start the ICE Maker Connect the Tubing to the RefrigeratorTurn the Water on AT the Shut OFF Valve Plug in the RefrigeratorCheck if Understanding Sounds YOU MAY HearRefrigerator does not Operate Vibration or Rattling NoiseCheck if Then Lights do not WorkCompressor Motor Seems to RUN TOO Much Doors are Difficult to Open Frost or ICE Crystals on Frozen FoodRefrigerator Seems to Make TOO Much Noise Cubes Produced by Icemaker are TOO Small