Kenmore 795.7130-K manual Removing Refrigerator Handle, Mounting Fasteners

Page 9

 

 

TOOLS YOU

MAY NEED

 

 

 

1/4 in

 

_

f/_

3/32 in

 

3/8 in

 

 

u

 

I _

10 mm

Phillips screwdriver

Flat head screwdriver

__

1/4 in 1

Hex head socket wrench

Allen wrench

NOTE: It is always recommended that the doors be removed when it is necessary to move the refrigerator through a narrow opening. If it is necessary to remove the handles follow the directions below.

NOTE: Handle appearance may vary from illustrations on this page.

HOW TO REMOVE DOOR HANDLE

1.Removing Refrigerator Handle

•Loosen the set screws with the 3/32" Allen wrench and remove the handle.

NOTE: If the handle mounting fasteners

need to be tightened or removed, use a 1/4" Allen wrench.

Mounting

Fasteners

Screw

Allen Wrench

2.Removing Freezer Drawer Handle

•Loosen the set screws located on the lower side of the handle with the 3/32" Allen wrench and remove the handle.

NOTE: If the handle mounting fasteners

need to be tightened or removed, use a 1/4" Allen wrench.

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Models / Modelos / Modeles 795.7130-k Ill tHow to remove Door handle Removing Replacing Parts and Features Refrigerator InstallationCare and Cleaning Freezer SectionDisclaimer of implied warranties limitation of remedies One Year Limited WarrantyMY-HOME Master Protection AgreementsPage To Connect Electricity Before YOU Throw Away Your OLD Refrigerator Or FreezerRecommended Grounding Method USE of Extension CordsUsethissectionto becomemorefamiliarwiththepartsandfeatures Base Grille Installation InstallationUnpacking Your Refrigerator EXTRemoving Refrigerator Handle Mounting FastenersAllen Wrench Removing Freezer Drawer Handle Removing Refrigerator Door Note Handle appearance may vary HOW to Remove Refrigerator DoorLeft Door Right DoorReplacing Refrigerator Door Right Door Removing Pull out Drawer HOW to Remove and Install the Pull OUT DrawerHOW to Remove and Install Installing Pull out DrawerPull OUT Drawer Leveling and Door Alignment LevelingDoor Alignment Setting the Controls Door AlarmEnsuring Proper AIR Circulation MULTI-FLOWFood Storage Guide Adjusting Control SettingsStoring Frozen Food Refrigerator Shelves Sliding Out Shelves optional on some modelsTo remove a sliding shelf from its metal frame On some models PantryCrisper Humidity Control on some models Optibin Crispers on some modelsCrisper Cover with Lattice on Inner Surface on some modelsModular Door Bins EGG BOX Some models Dairy BINDurabase on some models ICE BIN on some modelsGLIDE- OUT Drawer Basket on some models Light Bulb Replacement General Cleaning TipsOutside Door Liners and GasketsWhen YOU GO on Vacation Power InterruptionsWhen YOU Move To change the freezer lightIcemaker When YOU should SET the Icemaker Power Switch to O OFFOperation Instructions Normal Sounds YOU MAY HearPower drill Before YOU BeginWhat YOU will Need Shut OFF the Main Water Supply Turn the Water on AT the Shut OFF Valve Connect the Tubing to the RefrigeratorPlug in the Refrigerator Start the ICE MakerRefrigerator does not Operate Understanding Sounds YOU MAY HearVibration or Rattling Noise Check ifLights do not Work Compressor Motor Seems to RUN TOO MuchCheck if Then Refrigerator Seems to Make TOO Much Noise Frost or ICE Crystals on Frozen FoodCubes Produced by Icemaker are TOO Small Doors are Difficult to Open
Top Page Image Contents