Kenmore 795.7130-K Before YOU Throw Away Your OLD Refrigerator Or Freezer, To Connect Electricity

Page 6

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous...

even if they will sit for "just a few days". If you are getting rid of your old refrigerator, please follow the instructions at right to help prevent accidents.

Your old refrigerator may have a cooling system that used CFCs (chlorofluorocarbons). CFCs are believed to harm stratospheric Ozone.

BEFORE YOU THROW AWAY

YOUR OLD REFRIGERATOR

OR FREEZER

-Take off the doors.

*Leave the shelves in place so that, children may not easily climb inside.

For proper disposal of the product, please contact your local regulatory agency.

If you are throwing away your old refrigerator, make sure the CFC refrigerant is removed for proper disposal by a qualified servicer. If you intentionally release this CFC refrigerant, you can be subject to fines and imprisonment under provisions of environmental legislation.

IMPORTANT: Please read carefully.

TO CONNECT ELECTRICITY

Electrical Shock Hazard

FOR YOUR PERSONAL SAFETY, this appliance must be properly grounded. Have the wall outlet and the circuit checked by a qualified electrician to make sure the outlet is properly grounded.

3-prong grounding type

wall receptacle _ _-_

3-prong grounding plug

Use of an extension cord will increase the clearance needed for the back of the refrigerator. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid any hazard.

RECOMMENDED GROUNDING METHOD

The refrigerator should always be plugged into its own individual properly grounded electrical outlet rated for

115 volts, 60Hz, AC only and fused at 15 or 20 amperes. This provides the best performance and also prevents

overloading house wiring circuits which could cause a fire hazard from overheated wires. It is recommended

that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.

Ensure proper ground exists before use.

USE OF EXTENSION CORDS

Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL-listed (in the United States), 3-wire grounding type appliance extension cord having a grounding type plug and outlet, and that the electrical rating of the cord be 15 amperes (minimum) and 120 volts.

Where a standard two-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded three-prong wall outlet. Do not, under any circumstances, cut or remove the third (Ground) prong from the power cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator Control or Freezer Control, depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (thermostat, refrigerator control or freezer control, depending on the model) to the desired setting.

Image 6
Contents Ill t Models / Modelos / Modeles 795.7130-kCare and Cleaning Parts and Features Refrigerator InstallationHow to remove Door handle Removing Replacing Freezer SectionOne Year Limited Warranty Disclaimer of implied warranties limitation of remediesMaster Protection Agreements MY-HOMEPage Recommended Grounding Method Before YOU Throw Away Your OLD Refrigerator Or FreezerTo Connect Electricity USE of Extension CordsUsethissectionto becomemorefamiliarwiththepartsandfeatures Unpacking Your Refrigerator InstallationBase Grille Installation EXTRemoving Refrigerator Handle Mounting FastenersAllen Wrench Removing Freezer Drawer Handle Left Door HOW to Remove Refrigerator DoorRemoving Refrigerator Door Note Handle appearance may vary Right DoorReplacing Refrigerator Door Right Door HOW to Remove and Install the Pull OUT Drawer Removing Pull out DrawerHOW to Remove and Install Installing Pull out DrawerPull OUT Drawer Leveling and Door Alignment LevelingDoor Alignment Ensuring Proper AIR Circulation Door AlarmSetting the Controls MULTI-FLOWAdjusting Control Settings Food Storage GuideStoring Frozen Food Refrigerator Shelves Sliding Out Shelves optional on some modelsTo remove a sliding shelf from its metal frame Crisper Humidity Control on some models PantryOn some models Optibin Crispers on some modelsCrisper Cover with Lattice on Inner Surface on some modelsModular Door Bins Durabase on some models Dairy BINEGG BOX Some models ICE BIN on some modelsGLIDE- OUT Drawer Basket on some models Outside General Cleaning TipsLight Bulb Replacement Door Liners and GasketsWhen YOU Move Power InterruptionsWhen YOU GO on Vacation To change the freezer lightOperation Instructions When YOU should SET the Icemaker Power Switch to O OFFIcemaker Normal Sounds YOU MAY HearPower drill Before YOU BeginWhat YOU will Need Shut OFF the Main Water Supply Plug in the Refrigerator Connect the Tubing to the RefrigeratorTurn the Water on AT the Shut OFF Valve Start the ICE MakerVibration or Rattling Noise Understanding Sounds YOU MAY HearRefrigerator does not Operate Check ifLights do not Work Compressor Motor Seems to RUN TOO MuchCheck if Then Cubes Produced by Icemaker are TOO Small Frost or ICE Crystals on Frozen FoodRefrigerator Seems to Make TOO Much Noise Doors are Difficult to Open