Kenmore 795.7130-K manual Pantry, On some models, Crisper Humidity Control on some models

Page 19

PANTRY

(on some models)

Adjust the control to desired temperature by moving from COLD to COLDER,

Pull forward to open, Lift slightly and pull it out to remove,

CRISPER HUMIDITY CONTROL (on some models)

You can control the amount of humidity in the moisture-

sealed crispers, Adjust the control to any setting between "FRUIT" and "VEGETABLE",

"FRUIT" Lets moist air out from crisper for best storage of fruits,

"VEGETABLE" Keeps moist air in crisper for best storage of fresh, leafy vegetables,

jJ

n

f

FRUITS / VEGETABLES

J

To remove the glass:

1.Lift up the glass after inserting a screwdriver under the crisper cover.

2.Pull glass cover up and out.

To remove the crisper cover support:

NOTE: Remove glass before removing the crisper

cover support.

While holding the crisper cover support with both hands (as shown in the image below). Pull

forward and slightly lift the front part.

OPTIBIN CRISPERS (on some models)

The OptiBin Crispers provide fresher-tasting fruit and vegetables by letting you easily control humidity inside the crisper. The OptiBin Crispers include: 1) a humidity control knob at the front of the crisper cover and 2) a

large lattice on the inner surface of the cover to hold or release moisture.

To remove the crisper:

1.Slide crisper straight out to the stop.

2.Lift the front of the crisper, then pull it out to remove.

3.Replace the crisper by sliding it back in fully past the drawer stop.

r_WARNING: Be careful when handling the glass cover since the glass is not attached to the cover.

To remove the glass:

1.Lift up the glass after inserting a screwdriver under the crisper cover.

2.Pull up and out.

19

Image 19

Contents Models / Modelos / Modeles 795.7130-k Ill tFreezer Section Parts and Features Refrigerator InstallationHow to remove Door handle Removing Replacing Care and CleaningDisclaimer of implied warranties limitation of remedies One Year Limited WarrantyMY-HOME Master Protection AgreementsPage USE of Extension Cords Before YOU Throw Away Your OLD Refrigerator Or FreezerTo Connect Electricity Recommended Grounding MethodUsethissectionto becomemorefamiliarwiththepartsandfeatures EXT InstallationBase Grille Installation Unpacking Your RefrigeratorMounting Fasteners Removing Refrigerator HandleAllen Wrench Removing Freezer Drawer Handle Right Door HOW to Remove Refrigerator DoorRemoving Refrigerator Door Note Handle appearance may vary Left DoorReplacing Refrigerator Door Right Door Removing Pull out Drawer HOW to Remove and Install the Pull OUT DrawerInstalling Pull out Drawer HOW to Remove and InstallPull OUT Drawer Leveling Leveling and Door AlignmentDoor Alignment MULTI-FLOW Door AlarmSetting the Controls Ensuring Proper AIR CirculationFood Storage Guide Adjusting Control SettingsStoring Frozen Food Sliding Out Shelves optional on some models Refrigerator ShelvesTo remove a sliding shelf from its metal frame Optibin Crispers on some models PantryOn some models Crisper Humidity Control on some modelsSurface on some models Crisper Cover with Lattice on InnerModular Door Bins ICE BIN on some models Dairy BINEGG BOX Some models Durabase on some modelsGLIDE- OUT Drawer Basket on some models Door Liners and Gaskets General Cleaning TipsLight Bulb Replacement OutsideTo change the freezer light Power InterruptionsWhen YOU GO on Vacation When YOU MoveNormal Sounds YOU MAY Hear When YOU should SET the Icemaker Power Switch to O OFFIcemaker Operation InstructionsBefore YOU Begin Power drillWhat YOU will Need Shut OFF the Main Water Supply Start the ICE Maker Connect the Tubing to the RefrigeratorTurn the Water on AT the Shut OFF Valve Plug in the RefrigeratorCheck if Understanding Sounds YOU MAY HearRefrigerator does not Operate Vibration or Rattling NoiseCompressor Motor Seems to RUN TOO Much Lights do not WorkCheck if Then Doors are Difficult to Open Frost or ICE Crystals on Frozen FoodRefrigerator Seems to Make TOO Much Noise Cubes Produced by Icemaker are TOO Small