Kenmore 795.7756, 795.7757 manual Refrigerator Shelves, Sliding Out Shelves

REFRIGERATOR SHELVES

The shelves in your refrigerator are adjustable to meet your individual storage needs. Your model may have glass or wire shelves.

Storing similar food items together in your refrigerator and adjusting the shelves to fit different heights of items will make finding the exact item you want easier; it will also reduce the amount of time the refrigerator door is open, saving energy.

IMPORTANT: Do not clean glass shelves with warm water when they are cold. Shelves may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, glass shelves are made with tempered glass, which will shatter into small pebble- sized pieces.

NOTE: Glass shelves are heavy. Use special care when removing them to avoid dropping them.

Adjusting Shelves

Remove shelves from the shipping position and replace shelves in the position you want.

•To remove a shelf--Tilt up the front of the shelf in the direction of (1) and lift it in the direction of (2). Pull the shelf out.

•To reinstall a shelf--Tiltthe front of the shelf up and guide the shelf hooks into the slots at a desired height. Then lower the front of the shelf so that the hooks drop into the slots.

_, CAUTION: Make sure that shelves are level from one side to the other. Failure to do so may result in the shelf falling or spilling food.

Sliding Out Shelves

You can slide glass shelves in and out of your refrigerator as follows.

•To slide the shelf out, carefully pull front of shelf toward you.

•To slide shelf in, push shelf in until it stops.

BOTTLE HOLDER (795.7757* Model Only)

Bottles can be stored laterally with this bottle holder. It can be attached to any shelf.

Bottle holder can be removed by pulling it straight out and installed by placing it at the end of the shelf you want and pushing it inward.

, ¢

21