Kenmore 2211835 Caring for Your Refrigerator, To clean your refrigerator, Control Panel Light

CARING FOR YOUR REFRIGERATOR

Explosion Hazard

Use nonflammable cleaner.

Failure to do so can result in death, explosion, or fire.

Both the refrigerator and freezer sections defrost automatically. However, clean both sections about once a month to prevent odors from building up. Wipe up spills immediately.

To clean your refrigerator:,

1.Unplug refrigerator or disconnect power.

2.Remove all removable parts from inside, such as shelves, crispers, etc.

3.Hand wash, rinse, and dry removable parts and interior surfaces thoroughly. Use a clean sponge or soft cloth and a mild detergent in warm water.

•Do not use abrasive or harsh cleaners such as window sprays, scouring cleansers, flammable fluids, cleaning waxes, concentrated detergents, bleaches or cleansers containing petroleum products on plastic parts, interior and door liners or gaskets.

•Do not use paper towels, scouring pads, or other harsh cleaning tools. These can scratch or damage materials.

•To help remove odors, you can wash interior walls with a mixture of warm water and baking soda (2 tbs to 1 qt. [26 g to .95 L] of water).

4.Wash stainless steel and painted metal exteriors with a clean

sponge or soft cloth and a mild detergent in warm water. Do not use abrasive or harsh cleaners. Dry thoroughly with a soft cloth.

For additional protection against damage to painted metal exteriors, apply appliance wax (or auto paste wax) with a clean, soft cloth. Do not wax plastic parts.

5.Clean the condenser coils regularly. Coils may need to be cleaned as often as every other month. This may help save

energy.

Style I - Condenser coils behind base grille:

•Remove the base grille (see the "Base Grille" section).

•Use a vacuum with an extended attachment to clean the condenser coils when they are dusty or dirty.

•Replace the base grille when finished.

Style 2 - Condenser coils in back of the refrigerator:

•Pull refrigerator out away from the wall (see the "Unpacking Your Refrigerator" section).

•Vacuum coils when they are dusty or dirty.

•Roll refrigerator back into place. Make sure to leave 1 in. (2.5 cm) between the cabinet back and the wall.

•Check to see if the refrigerator is level.

6.Plug in refrigerator or reconnect power.

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to replace the bulb with one of the same size and shape. The dispenser light requires a heavy duty 10-watt bulb, All other lights require a 40-watt appliance bulb. Replacement bulbs are available from your dealer.

1.Unplug refrigerator or disconnect power.

2.Remove light shield when applicable as shown.

NOTE: To clean a light shield, wash it with warm water and a liquid detergent. Rinse and dry the shield well.

3.Remove light bulb and replace with one of the same size, shape and wattage.

4.Replace light shield when applicable as shown.

5.Plug in refrigerator or reconnect power.

Dispenser Light (on some models}

Reach through the dispenser area to remove and replace light bulb.

1

1. Dispenser Light

Control Panel Light

Reach behind the refrigerator control panel to remove and replace light bulb.

Crisper Light or Upper Freezer Light (on some models)

•Remove light shield by grasping the top center of the shield and pulling forward while turning it slightly to one side. If necessary, remove top crisper drawer to access crisper light shield.

Replace the light shield by inserting the tabs on one end into the slotted holes in the refrigerator or freezer liner. Then, carefully bend the shield at the center to insert the tabs on the other end.

18