- STEP 3: INSTALL FAUCET (cont.)-
B. ASSEMBLE FAUCET
ULTRAFILTER 150
1. Loosely assemble the base, spacer, washer and plastic nut onto the faucet stud.
2. Route the 1/4" red tubing through the sink or
countertop hole and connect to 1/4" barb on faucet.
3.Route the 3/8" black tubing through sink or the
countertop hole and connect to 3/8" barb on faucet.
4.Attach the 3/8" blue tubing to the faucet stud us- ing the tubing adaptor.
5.Lower faucet into place on the countertop, on the
underside of the countertop or sink slide the slotted
washer into place and tighten plastic nut. Tighten the nut so the faucet cannot move, but do not over- tighten.
UltraFilter 150
faucet & spout
H hole in sink or
b__i_bers
slotted washer _ (_
""
| washer |
|
|
| |
| hex nut _ | (_ | tubing | adaptor | |
| (connects | to | |||
|
|
| |||
1/4" | red tubing |
| /bottom | of stud) | |
|
|
|
| ||
from | RO drain |
| 3/8" black | tubing to | |
(connect to 1/4" |
| drain | point | (connect | |
barb on faucet) |
| to 3/8" | barb on faucet) | ||
/
3/8" blue tubing (connect to stud on faucet)
Figure 6
7
Problems, Questions? Call