Kenmore 625.38575 owner manual Install, RO Assembly, Assemble Faucet

STEP 3: INSTALL FAUCET (cont.)-

B. ASSEMBLE FAUCET

NOTE: If the faucet and spout are unassembled, slide the spout into the faucet body.

1.Snap LED assembly into electronics ring (may al-

ready be assembled) and o-ring in the groove on the bottom of the ring and slide the chrome monitor ring onto the faucet stud. The monitor ring LED wire must

be routed through the sink or countertop hole and through the spacel; if spacer is used, (Figure 6). NOTE: If you route the RO drain tubing directly to the

drain point, disregard steps 2 and 4 below and follow directions on page 17.

2.Take the 30" length of 3 / 8" black tubing and push one end onto the 3/8" faucet barb fitting (Figure 6).

3.Move the RO system into position, under the sink. (Referring to page 7, hang the system on cabinet wall, or lay on the floor surface, as desired.)

4.Route the 1/4" red tubing fronl the bottom, up

through the faucet mounting hole. Push the end of the tubing onto the 1/4" faucet barb fitting.

5.Work tubing and the faucet stud down, into the

mounting hole.

6.On the underside of the sink or countertop, slide the spacel; washer and hex nut on the faucet stud. The

spacer can be flipped depending on the countertop thickness. Make sure that the LED wire is in a position so that it will not be cut, pinched or kinked before tight- ening the faucet assembly. Tighten the hex nut securely.

7.Connect the 1/ 4" blue tubing &om faucet to the 3 / 8" blue tubing from the RO using the 1/4" x 3/8" quick connector (Figure 6).

Note: See tubing connection procedures on page 14. For

ease of service and maintenance, keep tubing lengths long enough so removal of the RO system from under the sink is possible.

STEP 4: INSTALL

Hang the assembly on the included hanger washers, or lay on the cabinet flool; as desired.

1. Refer to Figure 7 for wall mounting. Hold the assem- bly up to the wall surface and mark locations for the

hanger washers. Distance needed is 7.2" (approx. 7-7/32") apart.

2.Install hanger washers at least 15-1/2" up from the cabinet flool; allowing room to remove sumps from fit-

ter heads. Wood screws are provided, or obtain other fasteners as needed.

3.Connect telephone style wire to the receptacle on the

electronics board, located on the top of the RO unit.

Route the wire through the strain relief notch on the side of the manifold.

7

spacer ----.._ _

washer---_.._ hex nub---_

1/4" red tubing from RO drain

(connect to 1/4" barb on faucet)

3/8" blue tubing (connect to faucet. tubing)

Figure 6

RO ASSEMBLY

hanger washer (2)

screw

Figure 7

1/4" x 3/8" quick connect

3/8" black tubing to

drain point (connect to 3/8" barb on faucet)

/

-

15-1/2" min. up from floor

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line