Toro 38080, 38065 manual Disconnect the chute crank rod at the auger Figure

Auger Gearbox Service

9.The auger flighting is attached to the auger shaft with one bolt and locknut. Reach through the holes in the drum augers to access. On models without drum augers, the bolts are easily accessible (Figure 11).

1

Figure 11 MVC-533

1. Access hole

The auger assembly can be separated from the traction assembly. However, it is generally not necessary to work on the auger. Should the auger pulley be rusted on the shaft, it might be easier to remove the pulley with the traction assembly out of the way.

Secondary Method — Traction and Auger Housings Separated: Toro Models 38065 and 38080

1.Remove the belt cover. Loosen the belt guide and remove the auger belt (Figure 12).

Figure 12 2768-021

2.Drain the fuel and oil and stand the machine up on its auger. Support or brace to prevent tipping (Figure 13).

Figure 13 2768-027

3.Disconnect the chute crank rod at the auger (Figure 14).

Figure 14 MVC-534

4.Remove the lower cover from the traction assembly.

1 - 4 Two Stage Snowthrower Drive Systems Manual