Nilfisk-Advance America 5 manual Maintenance

Page 13

POSEIDON 5

english

6.3 Rolling up the electrical

 

lead and storing

 

accessories

6.4Storing the cleaner 1. Store the cleaner in a dry

(below 0°C)

room without danger of frost

 

or protect as below:

 

CAUTION!

,If the high-pressure cleaner is stored in a room with tempera- tures around or below 0°C, anti- freeze should be drawn into the pump beforehand:

1.Remove the water inlet hose from the cleaner.

2.Remove the spray lance.

3.Switch on the cleaner with the main switch in position „ I“ and activate trigger on the spray gun.

Switch off the cleaner after max. 3 minutes.

4.Connect the suction hose to the water inlet of the cleaner

Risk of tripping!

To prevent accidents, always carefully roll up the electrical lead.

1.Wind up the high pressure hose as illustrated.

2.Place the spray lance into the spray lance storage.

and place it in a tank contain- ing anti-freeze.

5.Switch on the cleaner with the main switch in position „ I „.

6.Hold the spray gun over the tank containing anti-freeze and operate it to start suc- tion.

7.During suction operate the spray gun two or three times.

8.Lift the suction hose from the tank containing anti-freeze and operate the spray gun to pump off the remaining anti- freeze.

9.Switching off the cleaner 10.To avoid any risks, store

the cleaner temporarily in a heated room before using it again.

7 Maintenance

7.1Maintenance plan

 

After the first 50

Every six months

As

Weekly

or 500 operating

operating hours

required

 

hours

 

 

 

7.2.1Cleaning water inlet filter

7.2.2Checking pump oil level

7.2.3Changing pump oil

12

1) Options / model variants

Image 13 Contents
POSEIDONG45 Contents English Symbols used to mark instructions Important safety instructionsFor your own safety TransportTesting Maintenance and repairOperation Electrical equipmentUnloader valve DescriptionPurpose Setting up the cleaner Before starting the cleanerFill up detergent tank1 Machines with high pressure hose reelElectrical connection Connecting the water supplyUse Connections Control / OperationTornado Lance Pressure regulationHigh pressure = clockwise + Low pressure = anticlockwise High pressure = MAX Low pressure = MIN.CHEMApplications and methods Vehicle Task Accessories Method Task Accessories Method After using the cleanerSwitching off the cleaner Disconnecting supply lines Buildings and EquipmentMaintenance Checking the pump oil level Maintenance work 7.2.1 Cleaning water inlet FilterChanging the pump oil Fault Cause Remedy English 8 TroubleshootingGuarantee EU Declaration of Conformity Recycling the cleanerFurther information Poseidon Technical DataPoseidon 5 XT