Makita EH 450, EH 620 manual Federal Emission Component Defect Warranty

Page 20

FEDERAL EMISSION COMPONENT DEFECT WARRANTY

EMISSION COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applicable in all States, except the State of California

Makita U.S.A., Inc., La Mirada, California, (herein “MAKITA) warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein “engine”) was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is freeof defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period.

For the components listed under PARTS COVERED, Makita Factory Service Center or service center authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U S . EPA regulations.

EMISSION COMPONENT DEFECT WARRANTY PERIOD

The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years.

PARTS COVERED

Listed below are the parts covered by the Emission Component Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part.

1)Fuel Metering System

(i)Carburetor and internal parts

(ii)Fuel filter, if applicable

(iii)Throttle stopper, if applicable

(iv)Choke System, if applicable

2)Air Induction System

(i)Air cleaner plate

(ii)Air cleaner case

*(iii) Air cleaner element

3)Ignition System

(i)Spark plug

(ii)Flywheel Magneto

(iii)Ignition Coil

4)Miscellaneous Items Used in Above Systems

(i)Fuel hoses. clamps and sealing gaskets

Image 20
Contents Hedge Trimmer Precautions before starting Read, Understand and FollowKeep the Area of Operation Clear of All Persons and Pets Wear Eye and Ear ProtectionPersonal protective equipment Intended use of the machineDo Not abuse the Trimmer Clean protective clothing at regular intervals MaintenanceTool Replacement Only use outdoorsMethod of operation Maintenance instructionsDamage caused by the use of any non-approved accessories Dimensions L x W x H 063x 288 xCutting length Clutch engagement speed LlminName of Major Parts Blade Throttle lever Front handle Rear handle Recoil starterHandling petroleum products FuelsirefuellingFuel and oil mirture Precautions Before Starting Diagrammatic-figureRefuelling Storage of fuelStarting the Machine Stopping the MachineMove the choke lever 3to position1-1 Cutting blade into an obstruction or your bodyOperation of the Machine CaseMaintenance Instructions Blade adjustmentBlade sharpening For aChecking and adjusting the idling speed Checking the spark plug Every 8 hours DailySupply of grease and lubricant Grease will come out from hereDaily checkup and maintenance Required by the carburetorStorage Maintenance ScheduleFault Location MANUFACTURER’SWARRANTY Coverage OWNER’S Warranty ResponsibilitiesLimited Warranty Warranty PeriodWhat is Covered Under this Warranty EMISSION-RELATED Parts Covered Under this WarrantyWhat is not Covered Under this Warranty Maintenance Schedule Procedure IntervalRepair and Replacement of EMISSION-RELATED Parts HOW to File a Warranty Claim Where to GET Warranty ServicesFederal Emission Component Defect Warranty Emission Component Defect Warranty PeriodOWNER’S Warranty RESPONSIBILIT1 ES HOW to Make a Claim M O 11-8,Sumiyoshi-cho, Anjo, Aichi 446-8502,Japan