Craftsman 917.270751 Engine, Clean AIR INTAKE/COOLING Areas, Belts, Lubrication, Clean AIR Screen

Page 19

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour. NOTE" The original equipment battery on your tractor is maintenance free. Do not

attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to "leak" power.

•Open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND

ADJUSTMENTS section of this manual).

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable.

Replace belts if they begin to slip from wear.

TRANSAXLE COOLING

Keep transaxle free from build-up of dirt and chaff which can restrict cooling.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SF, SG, or SH. Select the oil's SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

NOTE= Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°1=. Check your engine oil level more frequently to avoid possible engine damage from running low on oil.

Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one

year.

Check the crankcase oil level before starting the engine and after each eight

(8) hours of operation. Tighten oil fill cap/

dipstick securely each time you check the oil level.

TO CHANGE ENGINE OIL

Determine temperature range expected before oil change. All oil must meet API service classification SF, SG or SH.

•Be sure tractor is on level surface.

•Oil will drain more freely when warm.

•Catch oil in a suitable container.

•Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.

•Remove drain plug.

•After oil has drained completely, replace oil drain plug and tighten securely.

•Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill. For approximate capacity see "PRODUCT SPECIFICATIONS" section of this manual.

•Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oi! at "FULL" line on dipstick.

Air ,'

Oil Drain

Oil Fill Cap/

Dipstsick

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

CLEAN AIR INTAKE/COOLING AREAS

To insure proper cooling, make sure the grass screen, cooling fins, and other

external surfaces of the engine are kept clean at all times.

Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents CRI Ftsmrni Limited 90 DAY Warranty on Battery Safety RulesChildren General OperationSlope Operation Do notService Customer Responsibilities Product SpecificationsFl l Before Removing Tractor from Skid Attach Steering Wheel HOW to SET UP Your TractorTools Required for Assembly Check BatteryTo Drive Tractor OFF Skid Install Mulcher PlateCheck for Proper Position of ALL Belts To Convert to Bagging or DischargingCheck Tire Pressure Check Deck LevelnessJxl ,@ Lever Know Your TractorTo Move Forward and Backward HOW to USE Your Tractor to SET Parking BrakeStopping Throttle ControlTo Operate On Hills To Adjust Mower Cutting To Operate HeightTo Adjust Gauge Wheels AcautionADD Gasoline Before Starting the EngineCheck Engine OIL Level Warm Weather Starting 50 F and Above To Start EngineCold Weather Starting 50 F and below Mulching Mowing Tips Mowing TipsGeneral Recommendations Lubrication ChartBefore Each USE Tractor Belts Clean AIR INTAKE/COOLING AreasClean AIR Screen EngineSpark Plugs AIR FilterEngine OIL Filter MufflerTo Install Mower CleaningTo Remove Mower Belt Removal To Level Mower HousingTo Replace Motion Drive Belt Belt InstallationTo Adjust Brake Transaxle Gear Shift Lever AdjustmentTo Adjust Steering Wheel Alignment To Start Engine with a Weak BatteryFront Wheel TOE-IN/CAMBER Interlocks and Relays Replacing BatteryTo Remove Hood and Grill Assembly To Replace Headlight BulbTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor Cylinders TractorFuel System Engine OILCause ProblemCorrection Correction Troubleshooting ChartProblem CauseOFF Problem CauseOptional Tractor - Model Number SchematicTractor - Model Number 917,270751 Electrical Tractor - Model Number Switch, Interlock747604!2 111 HAsSlS AHOEHcLOSUEs114 Keeper Belt Rear Lh Stl P930 Tractor --MODEL Number Chassis and Enclosures13 172107X010 Panel, Dash, R.H 30 164918X558 Fend/FtrestTractor - Model Number Ground Drive 113 !27285X Strap Torque 90 Degrees Tractor - Model Number Ground DriveIti Tractor - Model Number 917.270751 Steering Assembly169839 139768154427 169840Tractor - Model Number Engine Engine 134300 140123140551 71110616Wheels & Tires DecalsTractor - Model Number Lift Assembly KEY Part NO. NO.DESCRIPTION 117 Tractor - Model Number Mower DeckTractor - Model Number Mower Deck Numbers Here Part Description 1026 929216 Requiresspecialtools 265Instructionmanual 573 635578 363Fuel Transfer Tube KEY Part NO. no Page Page Page Page Suggested Guide for Sighting Slopes for Safe Operation Days a week Get it fixed, at your home or ours

917.270751 specifications

The Craftsman 917.270751 is a powerful lawn tractor designed for homeowners who demand efficiency and performance in maintaining their lawns. This model seamlessly combines cutting-edge technology, user-friendly features, and durable construction to provide a reliable solution for lawn care.

One of the standout features of the Craftsman 917.270751 is its robust engine. Equipped with a 21.5 HP Briggs & Stratton engine, it offers ample power to tackle various mowing tasks. This engine is designed for smooth operation and durability, ensuring that it can handle large yards and diverse terrain with ease. The automatic transmission further enhances the user experience by allowing smooth speed transitions without the need for manual gear changes.

Another noteworthy characteristic of the Craftsman 917.270751 is its cutting deck. The model features a 42-inch cutting deck, which provides a wide mowing path for efficient grass cutting. This size is ideal for medium to large lawns, allowing users to complete their mowing tasks in less time. The deck is designed for quick height adjustments, accommodating various grass lengths and ensuring a clean, precise cut every time.

The tractor also includes the innovative mulching capability, allowing users to finely chop grass clippings and return them to the lawn, enhancing soil health and reducing waste. This feature not only saves time on yard maintenance but also promotes a healthier lawn ecosystem.

User comfort and convenience are prioritized in the Craftsman 917.270751. The adjustable seat provides ergonomic support during long mowing sessions, while the easy-to-use controls ensure that operators of all skill levels can navigate the tractor effortlessly. Coupled with a tight turning radius, maneuvering around flower beds and tight corners becomes a hassle-free task.

In terms of durability, the Craftsman 917.270751 is built with a heavy-duty steel frame and deck, ensuring it can withstand the challenges of regular use. The tractor comes with a warranty, providing peace of mind for owners regarding its longevity and performance.

In summary, the Craftsman 917.270751 stands out as a well-rounded lawn tractor equipped with features designed for power, efficiency, and user comfort. Its combination of a reliable engine, versatile cutting deck, and innovative technology makes it an excellent choice for homeowners seeking to maintain a pristine lawn with ease.
Top Page Image Contents