Craftsman 917.270751 To Start Engine with a Weak Battery, To Adjust Steering Wheel Alignment

Page 24

Gearshift Lever

Neutral

Lock Gate

 

Adjustment

Bolt

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steering wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized

service center/department.

TO REMOVE WHEEL FOR REPAIRS

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

Washers

Retaining

Ring

 

I

 

Axle Cover

Square

Key

--

(Rear

Wheel Only)

TO START ENGINE WITH A WEAK

BATTERY

_I, CAUTION: Lead-acidbatteries generate explosive gases. Keep sparks, flame and smoking materials away from

batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the

engine, it should be recharged. (See "BATTERY" in the MAINTANCE section of

this manual).

If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor Is equipped

with a 12 volt negative grounded system. The other vehicle must also be a 12 volt

negative grounded system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each

battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

Positive Terminal

Negative Terminal

iii_!_iil__i_!i

J

Chassis

][&Cables

Battery

Charged

Positive Terminal

Negative Terminal

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents CRI Ftsmrni Safety Rules Limited 90 DAY Warranty on BatteryGeneral Operation Slope OperationDo not ChildrenService Product Specifications Customer ResponsibilitiesFl l HOW to SET UP Your Tractor Tools Required for AssemblyCheck Battery Before Removing Tractor from Skid Attach Steering WheelInstall Mulcher Plate To Drive Tractor OFF SkidTo Convert to Bagging or Discharging Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsJxl ,@ Know Your Tractor LeverHOW to USE Your Tractor to SET Parking Brake StoppingThrottle Control To Move Forward and BackwardTo Adjust Mower Cutting To Operate Height To Adjust Gauge WheelsAcaution To Operate On HillsBefore Starting the Engine ADD GasolineCheck Engine OIL Level To Start Engine Warm Weather Starting 50 F and AboveCold Weather Starting 50 F and below Mowing Tips Mulching Mowing TipsLubrication Chart General RecommendationsBefore Each USE Tractor Clean AIR INTAKE/COOLING Areas Clean AIR ScreenEngine BeltsAIR Filter Engine OIL FilterMuffler Spark PlugsCleaning To Install MowerTo Remove Mower To Level Mower Housing Belt RemovalBelt Installation To Adjust BrakeTransaxle Gear Shift Lever Adjustment To Replace Motion Drive BeltTo Start Engine with a Weak Battery To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER Replacing Battery To Remove Hood and Grill AssemblyTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor Tractor Fuel SystemEngine OIL CylindersProblem CauseCorrection Troubleshooting Chart ProblemCause CorrectionProblem Cause OFFTractor - Model Number Schematic OptionalTractor - Model Number 917,270751 Electrical Switch, Interlock Tractor - Model Number747604!2 HAsSlS AHOEHcLOSUEs 111Tractor --MODEL Number Chassis and Enclosures 13 172107X010 Panel, Dash, R.H30 164918X558 Fend/Ftrest 114 Keeper Belt Rear Lh Stl P930Tractor - Model Number Ground Drive Tractor - Model Number Ground Drive 113 !27285X Strap Torque 90 DegreesTractor - Model Number 917.270751 Steering Assembly Iti139768 154427169840 169839Tractor - Model Number Engine Engine 140123 14055171110616 134300Decals Wheels & TiresTractor - Model Number Lift Assembly KEY Part NO. NO.DESCRIPTION Tractor - Model Number Mower Deck 117Tractor - Model Number Mower Deck Numbers Here Part Description 929 216Requiresspecialtools 265 1026Instructionmanual 635 578363 573Fuel Transfer Tube KEY Part NO. no Page Page Page Page Suggested Guide for Sighting Slopes for Safe Operation Get it fixed, at your home or ours Days a week

917.270751 specifications

The Craftsman 917.270751 is a powerful lawn tractor designed for homeowners who demand efficiency and performance in maintaining their lawns. This model seamlessly combines cutting-edge technology, user-friendly features, and durable construction to provide a reliable solution for lawn care.

One of the standout features of the Craftsman 917.270751 is its robust engine. Equipped with a 21.5 HP Briggs & Stratton engine, it offers ample power to tackle various mowing tasks. This engine is designed for smooth operation and durability, ensuring that it can handle large yards and diverse terrain with ease. The automatic transmission further enhances the user experience by allowing smooth speed transitions without the need for manual gear changes.

Another noteworthy characteristic of the Craftsman 917.270751 is its cutting deck. The model features a 42-inch cutting deck, which provides a wide mowing path for efficient grass cutting. This size is ideal for medium to large lawns, allowing users to complete their mowing tasks in less time. The deck is designed for quick height adjustments, accommodating various grass lengths and ensuring a clean, precise cut every time.

The tractor also includes the innovative mulching capability, allowing users to finely chop grass clippings and return them to the lawn, enhancing soil health and reducing waste. This feature not only saves time on yard maintenance but also promotes a healthier lawn ecosystem.

User comfort and convenience are prioritized in the Craftsman 917.270751. The adjustable seat provides ergonomic support during long mowing sessions, while the easy-to-use controls ensure that operators of all skill levels can navigate the tractor effortlessly. Coupled with a tight turning radius, maneuvering around flower beds and tight corners becomes a hassle-free task.

In terms of durability, the Craftsman 917.270751 is built with a heavy-duty steel frame and deck, ensuring it can withstand the challenges of regular use. The tractor comes with a warranty, providing peace of mind for owners regarding its longevity and performance.

In summary, the Craftsman 917.270751 stands out as a well-rounded lawn tractor equipped with features designed for power, efficiency, and user comfort. Its combination of a reliable engine, versatile cutting deck, and innovative technology makes it an excellent choice for homeowners seeking to maintain a pristine lawn with ease.
Top Page Image Contents