Craftsman 917.2759 manual To Start Engine, Automatic Transmission Warm UP

Page 14

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

1.Be sure freewheel control is in the

transmission engaged position.

2.Sit on seat in operating position,

depress clutch/brake pedal and set parking brake.

3.Place motion control lever in neutral

(N)position.

4.Move attachment clutch to disengaged position.

5.Move throttle control to fast position

6.Pull choke control out for a cold engine start attempt. For a warm engine start

attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

7.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do

not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke con- trol out and retry.

WARM WEATHER STARTING (50 ° F and above)

8.When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out

slightly for a few seconds and then continue to push the control in slowly.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50 ° F and

below)

8.When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the en- gine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a

few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

Before driving the unit in cold weather,

the transmission should be warmed up as follows:

1.Be sure the tractor is on level ground.

2.Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

3.Allow one minute for transmission to

warm up. This can be done during the engine warm up period.

The attachments can be used during the engine warm-up period after the

transmission has been warmed up and may require the choke control be pulled

out slightly.

NOTE: If at a high altitude (above 3000

feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance

(see "TO ADJUST CARBURETOR" in the

Service and Adjustments section of this manual).

PURGE TRANSMISSION

_I, CAUTION: Never engage or dis- engage freewheel lever while the engine is running.

To ensure proper operation and per-

formance, it is recommended that the

transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the trans- mission which may have developed during shipping of your tractor.

IMPORTANT." Should your transmission require removal for service or replace- ment, it should be purged after reinstall- ation before operating the tractor.

1.Place tractor safely on level surface with engine off and parking brake set.

2.Disengage transmission by placing

freewheel control in disengaged posi-

tion (See "TO TRANSPORT" in this section of manual).

3.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly disengage clutch/brake pedal.

14

Image 14
Contents Crrftsmrh Limited Warrantyon Craftsmanriding Equipment Limited Warranty on BatteryGeneral Operation IV. Towing Service Safe Handling of GasolineII. Slope Operation General Service For prices and additional information call 1=800=827=6655 Sears Installation ServiceRepair Protection To Remove Tractor from Carton Check BatteryAdjust Seat Unpack CartonALL Belts ChecklistCheck Deck Levelness Check Brake System@@@@ Will result in death or serious injuryKnow Your Tractor Parking HOW to USE Your TractorStopping MoveTo Operate Mower To Adjust Gauge WheelsUsing the Reverse Operation System Transmission Disengaged To TransportTo Operate on Hills Towing Carts and Other ATTACH- MentsTo Start Engine Automatic Transmission Warm UPMowing Tips Asyoucomplete General RecommendationsCheck Operator Presence System To Change Engine OIL Engine LubricationClean AIR Screen To Service PRE-CLEANERTo Service Cartridge Clean AIR INTAKE/COOLING AreasSpark Plugs CleaningMuffler IN-LINE Fuel FilterRemove Mower Vice or AdjustmentsTractor FRONT-TO-BACK Adjustment To Level Mower HousingSIDE-TO-SIDE Adjustment Mower Drive Belt Removal To Replace Mower Drive BeltBoth Front Plate Links Must be Equal in Length To Replace Mower Blade Secondary Drive Belt Install NEW Mower Blade Secondary Drive BeltReinstall Mower Drive Belt Remove Mower Drive BeltWith parking To Attach Jumper Cables Replacing BatteryTo Start Engine with a Weak BAT- Tery To Replace Fuse To Adjust Throttle Control CableTo Replace Headlight Bulb To Remove Hood and Grill AS- SemblyTo Adjust Carburetor Preliminary SettingTo Adjust Choke Control Final SettingCylinders Fuel SystemEngine OIL OtherWill not ProblemLoss Power Clicks butEngine dies whet tractor is shifted Problem CauseVibration Operator leaves seat with Attach merit Clutch engagedWorking ProblemcauseDischarge Loss of driveSchematic Tractor = = Model NumberTractor = = Model Number Electrical Electrical KEY Part DESCRiPTiONTractor = = Model Number 917.275900 Chassis and Enclosures Tractor = = Model Number 917.275900 Chassis and Enclosures KEY PartGround Drive Tractor . . Model Number Description Tractor - Model Number Ground DrivePart Tractor = = Model Number Description Tractor - Model Number Tractor = = Model Number Seat Assembly Decals KEY PartLiFT Assembly Tractor - Model NumberMower Deck Number 111111 Tractor = = Model Cylinder Head Valve and Breather Crankcase KEY ENGINE=MODELHEAD/VALVE/BR Eath ER ITO AiR INTAKE/FILTRATION Kohler ENGINE=MODEL Number CV730, Type Number Tractor -- Model Number OiL PAN/LUBRICATIONKohler ENGINE=MODEL Number CV730, Type Number Exhaust KEY Part Fuel SystemPage Degrees MAX Only Ride UP and Down HillNot Across Hill Iiiiiii!iii ,YourHome....iHiiiilHiiiHiHi 800LE.FOYERMC

917.2759 specifications

The Craftsman 917.2759 is a powerful lawn tractor designed for homeowners seeking efficiency and reliability in maintaining their lawns. This robust riding mower features a 42-inch cutting deck, which allows for a wide cutting path, ensuring that mowing tasks are completed swiftly. With a 19.5 horsepower Briggs & Stratton engine, the Craftsman 917.2759 delivers adequate power for various mowing conditions, from flat terrains to slightly hilly landscapes.

One of the key features of this tractor is its automatic transmission, which allows for smooth and effortless speed adjustments. Users can easily transition between forward and reverse without the hassle of shifting gears manually. This makes maneuvering around trees, flower beds, and other obstacles much simpler. The tractor also boasts a comfortable high-back seat, providing ample support during long mowing sessions.

Technologically advanced, the Craftsman 917.2759 includes a debris management system that prevents grass clippings from clogging the cutting deck. With its side discharge feature, the mower efficiently expels clippings to the side, promoting a cleaner mowing experience. For those who prefer to collect clippings, optional bagging systems are available, further enhancing the mower's versatility.

In terms of durability, the Craftsman 917.2759 is built with a heavy-duty steel frame and a reinforced cutting deck, ensuring it can withstand the wear and tear of regular use. The tire design offers excellent traction on various terrains, contributing to seamless movement across the lawn.

Another noteworthy characteristic of this tractor is its ease of maintenance. The placement of the engine and battery allows for straightforward access, making it convenient for users to perform routine checks. Additionally, the mower supports various attachments, making it adaptable for different gardening tasks, such as leaf collection, snow removal, and aeration.

Overall, the Craftsman 917.2759 is an excellent choice for homeowners looking for a reliable, feature-rich lawn tractor that can tackle various mowing tasks effectively. Its combination of power, comfort, and innovative technologies positions it as a valuable tool for maintaining a beautiful and healthy lawn.