Craftsman 917.2759 manual To Remove Tractor from Carton, Unpack Carton, Check Battery, Adjust Seat

Slope Sheet

Keys

For Future Use (2) Keys

Your new tractor has been assembled at the factory.

When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).

TO REMOVE TRACTOR FROM

CARTON

UNPACK CARTON

1.Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels flat.

2.Remove packing materials.

3.Remove protective materials from trac- tor hood and grille.

IMPORTANT: Check for and remove any

staplesin skid that may puncture tires where tractor is to roll off skid.

CHECK BATTERY

1.Lift hood to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instruc- tions).

JJ:l

,Slide seat until a comfortable position is reached which allows you to press

clutch/brake pedal all the way down.

,Get off seat without moving its ad- justed position.

5.Raise seat and tighten adjustment knob securely.

Adjustment.__Knob

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKiD (See

Operation section for location and

function of controls)

1.Press lift lever plunger and raise attachment lift lever to its highest po- sition.

2.Release parking brake by depressing

clutch/brake pedal. Labe3. Place freewheel control in "trans-

mission disengaged position" (See "TO TRANSPORT" in the Operation section

of this manual).

4. Roll tractor forward off skid.

ADJUST SEAT

1.Raise seat and loosen adjustment knob.

2.Lower seat into operating position and sit in seat.

7