Craftsman 917.27528 owner manual To Level Mower Housing, Bubble Between Lines m/b Bubble Level

8.Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown.

9.Position front plate assembly between front mower brackets. Raise deck and

plate assembly to align holes and insert flanged pins. Secure pins with double loop retainer springs between the plate assembly and mower brackets.

NOTE; To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower side-to-side to give space between plate and mower brackets.

IMPORTANT: Check belt for proper routing in all mower pulley grooves. 10.Engage belt tension rod by pushing

rod into locking bracket.

A CAUTION; Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

11.Connect anti-swaybar to chassis bracket under left footrest and retain

with double loop retainer spring.

12.If equipped, turn height adjustment knob clockwise to remove slack from

mower suspension.

13.Raise deck to highest position.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground such as a carport or garage. Make sure tires are properly inflated (See "PRODUCT SPECIFICA-

TIONS" section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT WITH

BUBBLE LEVEL

Bubble Between

Lines __m/b Bubble Level

_ Level Decal

Brake .._ Left Hand Footrest

y_	Lift Link
	ANd_ustment

ALTERNATE SIDE-TO-SIDE

ADJUSTMENT METHOD

•Raise mower to its highest position.

•Measure height from bottom edge of mower to ground level at front corners of mower. Distance "A" on both sides of mower should be the same.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Recheck measurements after adjust- ing.

Bottom Edge of Bottom Edge of

MA__rto-_ Ground Mower toiroun d

NOTE: If necessary, check side-to-side surface below tractor for levelness with a

long board and the bubble level.

•Using the lift lever, place mower in position where no part of the mower, including gauge wheels, is touching the ground.

•From left side of tractor, find the level decal on top of mower and place bubble level on decal as indicated.

•Mower is level side-to-side when bubble is between the two lines in the bubble level.

•If adjustment is necessary, under left hand footrest, turn lift link adjustment nut (above yellow cap) in appropriate

direction to bring bubble between the lines in the bubble level.

•Remove bubble level from mower and store in a safe place.

Suspension

Arm

Lift Link

Jstment

Nut

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side-to- side. If the following front-to-back adjustment is necessary, be sure to adjust

both front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is approximately 1/8" to 1/2" lower than the rear tip when the mower is in its

21 highest position.