Craftsman 917.27528 Front Wheel Camber, To Remove Wheel for Repairs, To Start Engine with a Weak

Page 26

FRONT WHEEL CAMBER

The front wheel camber is not adjustable

on your tractor. If damage has occurred to affect the front wheel camber, contact

contact a Sears or other qualified service center

TO REMOVE WHEEL FOR REPAIRS

FRONTWHEEL-

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal.

3.Repair tire and reassemble.

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover.

REAR WHEEL -

1.Block rear axle securely.

2.Remove five (5) hub bolts to allow wheel removal.

3.Repair tire and reassemble. Replace and tighten hub bolts securely.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and use tire sealant from Seam. l]re sealant

also prevents tire dry rot and corrosion.

Washers

Retaining

Axle

Cover

TO START ENGINE WITH A WEAK

w AERY

RNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from

batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the

engine, it should be recharged. (See "BATTERY" in the MAINTENANCE

section of this manual).

If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1.Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A-B),taking care not to short against tractor chassis.

2.Connect one end of the BLACK cable

to the NEGATIVE (-) terminal (C) of fully charged battery.

3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

Weak or Dead Fully Charged

BatteryBattery

REPLACING BATrERY

dIICAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at

the same time. Before connecting battery, remove metal bracelets, wristwatch

bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

1.Lift hood to raised position.

2.Remove terminal guard.

3.Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

4.Install new battery with terminals in same position as old battery.

5.Reinstall terminal guard.

6.First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.

7.Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut.

Tighten securely

8.Close terminal access doors.

9.Close hood.

26

Image 26
Contents Jcraftsmanj Sears Craftsman Help LineSears ServiceRepair Back CoverII. Slope Operation SafetyGeneral Operation YourDo not IV. ServiceMow up and down slopes, not across IlL ChildrenRemove obstacles such as rocks, tree limbs, etc Repair Agreement Product SpecificationsAPI-SF-SJ Customer ResponsibilitiesTo Remove Tractor from Carton Check BatteryInstall Seat Unpack CartonCheck for Proper Position ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemH L Knowyour Tractor Your Tractor Motion Drive Belt TensionHOW to USE Your Tractor To Operate On Hills Iicaution To Adjust Gauge WheelsTo Operate Mower Before Starting the Engine Purgetransmssion Automatic Transmission Warm UPMowing Tips Before Each USE Lubrication ChartGeneral Recommendations Operator Presence System BatteryTires Blade CareBelts Transaxle CoolingTransaxle Pump Fluid Engine LubricationClean AIR INTAKE/COOLING Areas To Service CartridgeClean AIR Screen CleaningTo Remove Mower Brake .. Left Hand Footrest Lift Link ANdustment To Level Mower HousingBubble Between Lines m/b Bubble Level To Replace Mower Drive Belt Both Front Links Must be EqualLength Arm ElectricPulley To Replace Mower Blade SEC- Ondary Drive BeltTo Replace Motion Drive Belt To Adjust Attachment ClutchTo Adjust Brake To Adjust Steering Wheel ALIGN- Ment Belt InstallationTransaxle Motion Control Lever Neutral Adjustment Front Wheel TOE-IN AdjustmentTo Start Engine with a Weak Front Wheel CamberTo Remove Wheel for Repairs To Attach Jumper CablesInterlocks and Relays To Adjust Throttle Control CableTo Replace Headlight Bulb To Replace FuseAcceleration Test To Adjust CarburetorReassemble air cleaner. Closed for Full Engine OIL EngineFuelsystem CylindersProblem Cause CorrectionTroubleshooting Chart Problem CauseFast Troubleshooting ChartProblem Cause Correction Tractor Model Number Schematic RelayTractor Model Number Electrical109748X Relay Asm 181883 TachometerRound Tractor Model Number ElectricalKEY Part NO. NO. Description Tractor Model Number 917.275280 Chassis and Enclosures 74780716 37 178516X615 Fender Pnt 17527843 136939 Bracket, Spnsn Front Lh 177143 Rod By PassTractor Model Number Ground Drive 16-18unc x 2-1/2 PARt122 72010520 Bolt Rdhd SQ 137648 127783 Pulley, Idler, Grooved 133 175468Stsrgn 121232X ¢ap,Spind 20 177646X418 Boot, SteeringSteering 23 152927 ScrewSpark Arrester KIT 180045 Shaft Asm., LiftVgt 155097 Tractor Model Number Lift Assembly121006X Rod Asm.. Lever 138057 159189 Lever Asm., Lift Rh 123935XNut, Lock 1/4 Lge Fig Gr Tractor Model Number Seat AssemblyPan, Seat 20 124238X Cap, SpringSeat2O13 Tractor Model Number DecalsWheels and Tires Tractor Model Number Mower Deck Part DescriptionTractor Model Number 917.275280 TRANSAXLE-MODEL Number ManifoId 139 161176 Washer 8od 265id 161142 178326 Spacer Assembly 169536 Odng 070 239 161127 OutputPlate 122 178329 Brake Yoke Arm, Brake 169529 203 178338 161155IzlU16 24-126-19-S Kit, breather cover w/gasket235011-S 545016-SIGNITION/ELECTRICAL Iblower Housing and Baffles KEY Part NO. NO.DESCRIPTION KEY Part NO. noStarting Systemj ENGINECONTROLSs 24-211-03-S KEY Part DescriptionKEY Part Not IllustratedFuel Systemj 24-853-90-S Kit, carburetor w/gaskets Includes Crankshaft IncludesGasket, exhaust Stud M8x1.25x33 12 -353-03-SPage Suggested Guide for Sighting Slopes for Safe Operation @ Sea RoebuckandCo 800-LE-.FOYER Mc888-SU4-1OGAR s

917.27528 specifications

The Craftsman 917.27528 is a powerful and versatile lawn tractor designed to deliver superior performance and ease of use for homeowners and gardening enthusiasts. Known for its robust construction and a host of user-friendly features, this model has earned a reputation for reliability and efficiency in lawn care.

One of the standout features of the Craftsman 917.27528 is its 24 horsepower Briggs & Stratton engine. This powerful engine ensures smooth operation and is capable of handling even the most demanding mowing tasks. The engine is paired with a versatile automatic transmission, allowing for effortless speed adjustments while mowing or navigating through various terrains. This means users can easily transition from cutting grass to tackling hilly areas without sacrificing performance.

The lawn tractor is equipped with a 42-inch cutting deck, designed for optimal cutting efficiency. The deck features a three-blade system that provides a clean and even cut across various grass types. One of the highlights of this cutting deck is its adjustable height settings, allowing users to customize the cut based on their lawn's specific needs. In addition to traditional mowing, the Craftsman 917.27528 is compatible with a range of attachments, including mulch kits, baggers, and tow-behind devices, further enhancing its versatility.

Comfort is a priority in the design of the Craftsman 917.27528. The tractor features an ergonomic seat and easy-to-reach controls that make long mowing sessions much more enjoyable. The inclusion of a lap bar for steering provides better maneuverability and control, especially in tight spaces.

In terms of maintenance, the Craftsman 917.27528 stands out for its user-friendly design. Features such as an easy-access oil drain and a removable deck make routine maintenance tasks such as oil changes and blade sharpening straightforward, encouraging owners to keep their equipment in optimal condition.

Overall, the Craftsman 917.27528 combines powerful performance with practical features, making it an excellent choice for homeowners seeking a reliable lawn tractor. Its blend of technology, comfort, and adaptability helps ensure that mowing the lawn is a hassle-free experience. Whether for maintaining a small yard or tackling larger areas, this lawn tractor proves itself as a valuable asset in lawn care.