Craftsman 917.27528 Transaxle Cooling, Transaxle Pump Fluid, Belts, Engine Lubrication, 3o 4o

NOTE: The odginal equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERYAND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to "leak" power.

1.Remove terminal guard.

2.Disconnect BLACK battery cable first then RED battery cable and remove

battery from tractor. ;_

3.Rinse the battery with plain water and dry.

4.Clean terminals and battery cable ends with wire brush until bright.

5.Coat terminals with grease or petro- leum jelly.

6.Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND

ADJUSTMENTS section of this manual).

TRANSAXLE COOLING

The transmission fan and cooling fins should be kept clean to assure proper cooling.

Do not attempt to clean fan or transmis- sion while engine is running or while the transmission is hot. To prevent possible damage to seals, do not use high pressure water or steam to clean transaxle.

•Inspect cooling fan to be sure fan blades are intact and clean.

•Inspect cooling fins for dirt, grass

clippings and other materials. To prevent damage to seals, do not use

compressed air or high pressure sprayer to clean cooling fins.

TRANSAXLE PUMP FLUID

The transaxle was sealed at the factory and

fluid maintenance is not required for the life of the transaxle. Should the transaxle ever

leak or require servicing, contact a Sears or other qualified service center.

V-BELTS

Check V-beltsfor deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable.

Replace belts if they begin to slip from wear.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SF-SJ. Select

the oil's SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

-20	0	30	60		80
-®	._o -,o	o	,_	_o	3o 4o

TEMPERATURE RANGE ANrnCIPATED BEFORE NEXT OIL CHANGE

Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one

year.

Check the crankcase oil level before starting the engine and after each eight

(8) hours of operation.

TO CHANGE ENGINE OIL

Determine temperature range expected before oil change. All oil must meet API service classification SF-SJ.

•Be sure tractor is on level surface.

•Oil will drain more freely when warm.

•Catch oil in a suitable container.

1.Remove oil fill cap/dipstick. Be careful

not to allow dirt to enter the engine when changing oil.

2.Remove yellow cap from end of drain valve and install the drain tube onto

the fitting.

Oil Drain Valve

Yellow

I ]_/L- Closed and

I I 1/ Locked

Drain Tube_ Position

3.Unlock drain valve by pushing upward slightly and turning counterclockwise.

4.To open, pull down on the drain valve.

5.After oil has drained completely, close and lock the drain valve by pushing upward and turning clockwise until the pin is in the locked position as shown.

6.Remove the drain tube and replace the cap onto the end of the drain valve.

7.Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not

overfill. For approximate capacity see

"PRODUCT SPECIFICATIONS" section of this manual.

8.Use gauge on oil fill cap/dipstick for checking level. Insert dipstick into the tube and rest the oil fill cap on the tube. Do not thread the cap onto the

tube when taking reading. Keep oil at "FULL" line on dipstick. Tighten cap onto the tube securely when finished.

18