Your new tractor has been assembled at the factory. Review the video cassette before you begin.
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
1.Cut, from top to bottom, along lines on all four corners of carton, and lay panels flat.
2.Remove packing materials.
3.Remove protective materials from
tractor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where tractor is to roll off skid.
CHECK BATTERY
1. Lift hood to raised position.
2.Release L.H. seat slide on seat pan by pulling out on adjustment handle and sliding it to the rear position exposing seat mounting holes from bottom. Slide R.H. slide to same rear position.
3.Mount rear of seat on slides using mounting bolts and lock washers as shown.
4.Pull out on adjustment handle and slide seat all the way forward. Install front mounting bolts and lock washers. Tighten all mounting bolts securely.
5.Lower seat into operating position and
sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle and pull out, slide seat to desired position and release adjustment handle.
NOTE: If this battery is put into service after month and year indicated on label
(label located between terminals) charge battery for minimum of one hour at 6-10
amps. (See "BAI-rERY" in Maintenance section of this manual for charging instructions).
Seat
L.h. Seat
Slide
Seat
Pan
Label | Seat Slide |
|
| Mounting Bolts W |
INSTALL SEAT
Seat position should be adjusted forward or backward so that the operator can
comfortably reach clutch/brake pedal and safely operate the tractor.
1.Remove the two (2) bolts and flat washers securing the seat to card- board packing. Keep the two (2) bolts only and place them with the two (2) identical bolts and four (4) washers in the parts bag. Discard the flat washers and cardboard packing.
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1.Press lift lever plunger and raise attachment lift lever to its highest position.
2.Release parking brake by depressing brake pedal.
3.Place freewheel control in transmis- sion disengaged position (See "To Transport" in the Operation section of this manual).
4.Roll tractor forward off skid.
Sears Craftsman Help Line
Jcraftsmanj
Back Cover
Service
Repair
Sears
Your
Safety
General Operation
II. Slope Operation
IlL Children
IV. Service
Mow up and down slopes, not across
Do not
Remove obstacles such as rocks, tree limbs, etc
Customer Responsibilities
Product Specifications
API-SF-SJ
Repair Agreement
Unpack Carton
Check Battery
Install Seat
To Remove Tractor from Carton
Check Brake System
Check Tire Pressure
Check Deck Levelness
Check for Proper Position ALL Belts
H L
Motion Drive Belt Tension
Knowyour Tractor Your Tractor
HOW to USE Your Tractor
To Operate Mower
To Adjust Gauge Wheels
To Operate On Hills Iicaution
Before Starting the Engine
Automatic Transmission Warm UP
Purgetransmssion
Mowing Tips
General Recommendations
Lubrication Chart
Before Each USE
Blade Care
Battery
Tires
Operator Presence System
Engine Lubrication
Transaxle Cooling
Transaxle Pump Fluid
Belts
Cleaning
To Service Cartridge
Clean AIR Screen
Clean AIR INTAKE/COOLING Areas
To Remove Mower
Bubble Between Lines m/b Bubble Level
To Level Mower Housing
Brake .. Left Hand Footrest Lift Link ANdustment
Length
Both Front Links Must be Equal
To Replace Mower Drive Belt
To Replace Mower Blade SEC- Ondary Drive Belt
Electric
Pulley
Arm
To Adjust Brake
To Adjust Attachment Clutch
To Replace Motion Drive Belt
Front Wheel TOE-IN Adjustment
Belt Installation
Transaxle Motion Control Lever Neutral Adjustment
To Adjust Steering Wheel ALIGN- Ment
To Attach Jumper Cables
Front Wheel Camber
To Remove Wheel for Repairs
To Start Engine with a Weak
To Replace Fuse
To Adjust Throttle Control Cable
To Replace Headlight Bulb
Interlocks and Relays
Reassemble air cleaner. Closed for Full
To Adjust Carburetor
Acceleration Test
Cylinders
Engine
Fuelsystem
Engine OIL
Cause Correction
Problem
Problem Cause
Troubleshooting Chart
Problem Cause Correction
Troubleshooting Chart
Fast
Relay
Tractor Model Number Schematic
Electrical
Tractor Model Number
KEY Part NO. NO. Description
Tractor Model Number Electrical
109748X Relay Asm 181883 TachometerRound
Tractor Model Number 917.275280 Chassis and Enclosures
177143 Rod By Pass
37 178516X615 Fender Pnt 175278
43 136939 Bracket, Spnsn Front Lh
74780716
Tractor Model Number Ground Drive
127783 Pulley, Idler, Grooved 133 175468
PARt
122 72010520 Bolt Rdhd SQ 137648
16-18unc x 2-1/2
Stsrgn
23 152927 Screw
20 177646X418 Boot, Steering
Steering
121232X ¢ap,Spind
Spark Arrester KIT
159189 Lever Asm., Lift Rh 123935X
Tractor Model Number Lift Assembly
121006X Rod Asm.. Lever 138057
180045 Shaft Asm., LiftVgt 155097
20 124238X Cap, SpringSeat
Tractor Model Number Seat Assembly
Pan, Seat
Nut, Lock 1/4 Lge Fig Gr
Wheels and Tires
Tractor Model Number Decals
2O13
Tractor Model Number Mower Deck
Description
Part
Tractor Model Number 917.275280 TRANSAXLE-MODEL Number
203 178338 161155
178326 Spacer Assembly 169536 Odng 070 239 161127 Output
Plate 122 178329 Brake Yoke Arm, Brake 169529
ManifoId 139 161176 Washer 8od 265id 161142
IzlU16
545016-S
Kit, breather cover w/gasket
235011-S
24-126-19-S
IGNITION/ELECTRICAL Iblower Housing and Baffles
KEY Part NO. no
KEY Part NO. NO.DESCRIPTION
Starting Systemj ENGINECONTROLSs
Not Illustrated
KEY Part Description
KEY Part
24-211-03-S
Fuel Systemj
12 -353-03-S
Crankshaft Includes
Gasket, exhaust Stud M8x1.25x33
24-853-90-S Kit, carburetor w/gaskets Includes
Page
Suggested Guide for Sighting Slopes for Safe Operation
888-SU4-1OGAR s
800-LE-.FOYER Mc
@ Sea RoebuckandCo