Craftsman 917.2720601 To Level Mower Housing, SIDE-TO-SIDE Adjustment, FRONT-TO-BACK Adjustment

Page 24

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure

tires are properly inflated (See "PROD-

UCT SPECIFICATIONS" section of this manual). If tires are over or underinflated, you will not propedy adjust your mower.

SIDE-TO-SIDE ADJUSTMENT

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift

link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjust- ing.

Bottom edge of

Bottom edge of

mower

to

 

mower to

ground

_

W

ground

 

A_- "_'"'_Ground Line

1TA

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side-to side. If the following front-to-backadjustment is necessary, be sure to adjust both front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 112" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjust- ments, check that both front links are

equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut "E"

on both front links an equal number of turns.

•When distance "D" is 1/8" to 1/2" lower

at front than rear, tighten nuts "F' against trunnion on both front links.

•To raise front of mower, loosen nut =F" from trunnion on both front links.

Tighten nut "E" on both front links an equal number of turns. The two front links must remain equal in length.

•When distance "D" is 1/8" to 1/2" lower

at front than rear, tighten nut "F" against trunnion on both front links.

•Recheck side-to-side adjustment.

.oNN, . ooj /- Mandrel

Both Front Links Should be Equal in Length

Nut =_

Trunnion_

Front Links

TO REPLACE MOWER BLADE DRIVE BELT

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

1.Remove mower from tractor (See "TO REMOVE MOWER" in this section of

manual).

2.Work belt off both mandrel pulleys and idler pulleys.

3.Pull belt away from mower.

BELT INSTALLATION -

1.Work belt around both mandrel pulleys and idler pulleys

2.Make sure belt is in all pulley grooves and inside all belt guides.

3.Install mower (See "To Install Mower"

24 in this section of this manual).

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Icraftsmani Sears Craftsman Help Line 5 am 5 pro, Mon SatLimited Warranty on Craftsman Riding Equipment II. Slope Operation General OperationIV. Service Do notPage Repair Agreement Customer ResponsibilitiesFor Future Use 28 x 1-1/4To Remove Tractor from Carton Before Removing Tractor from Skid Attach Steering WheelInstall Seat Label TerminalRelease parking brake by depressing clutch/brake pedal Install Mulcher Plate Check Brake System To Convertto Bagging or DischargingCheck Tire Pressure Check Deck LevelnessAutomatic Models only Know Your Tractor PlungerFreewheel Control Disengagages transmission for pushingHOW to USE Your Tractor To Adjust Gauge Wheels To Operate on HillsGaug To Operate MowerBefore Starting the Engine Check Engine OIL Level ADD GasolineTo Start Engine Automatictransmissionwarmup Purge TransmissionMowing Tips Mulching Mowing TipsLubrication Chart General RecommendationsCh=,v-Bait Before Each USEBattery TractorBrake Operation TiresEngine Clean AIR Screen Engine OIL FilterAIR Filter Cleaning Clean AIR INTAKE/COOLING AreasMuffler Spark PlugsTo Install Mower TractorTo Remove Mower PulleyTo Level Mower Housing SIDE-TO-SIDE AdjustmentFRONT-TO-BACK Adjustment Belt InstallationTo Adjust Brake With Parking BrakeNut Jam Nut To Replace Motion Drive BeltTransaxle Motion Control Lever Neutral Adjustment To Adjust Steering Wheel ALIGN- MentTransmission REMOVAL/REPLACE- Ment Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order Replacing BAI-FERYTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Carburetor Thr ttle Idle Speed AdjustingIAcceleration Test ScrewOther TractorEngine Troubleshooting Chart ProblemCause Correction Troubleshooting Chart Problem Cause CorrectionProblem Cause Correction FastSlow OFFSchematic Tractor --MODEL NumberTRACTOR-- Modelnumber ElectricalTractor --MODEL Number Electrical KEY Part DescriptionTractor -- Model Number 917.2720601 Chassis and Enclosures Tractor --MODEL Number 917.2720601 Chassis and Enclosures KEY Part DescriptionTRACTOR-- Model Number Grounddrive Ground Drive Tractor -- Model Number 917.2720601 Steering Assembly Tractor - Model Number 917.2720601 Steering Assembly KEY Part NO. NO. DescriptionTractor -- Model Number Engine Optional EquipmentSpark Arrester Tractor -- Model Number Liftassembly KEY Part NO. no DescriptionSeat Assembly Tractor --MODEL Number Decals Wheels & TiresMowerdeck Mower Deck Mi= Tractor -- Model Number Hydro Gear Transaxle - Model Number 142883Cylinder HEAD, Valve and Breather Crankcasej 041 03-S KEY Part NO. no3NITIONIELECTRICAL Blower Housing and Baffles AIR Intake Not Illustrated Starting System Engine Controls OIL PAN I Lubrication J OIL PAN/LUBRICATION Starting System KEY Part DescriptionCrankshaftexhaust SScrew, thread forming M5x0.8xl SKit, solenoid repairPage Suggested Guide for Sighting Slopes for Safe Operation 6am -11 pm, 7 daysaweek M 5 pm., CST, Mort.- Sat Rn.-8 p m. EST, M- F, 4 p m SSU-HOGAR sa 888-784.-6427

917.2720601 specifications

The Craftsman 917.2720601 is a standout lawn tractor that combines robust functionality with user-friendly features, making it a go-to choice for many homeowners looking to maintain their yards efficiently. With its powerful performance and innovative technologies, this model is designed to enhance the mowing experience while ensuring durability and reliability.

One of the main features of the Craftsman 917.2720601 is its engine. Powered by a reliable 19 horsepower Briggs & Stratton engine, it provides ample power to efficiently cut through thick grass and tackle various landscaping tasks. The engine is equipped with an automatic choke system, ensuring easy starts in various weather conditions.

The cutting deck plays a crucial role in the effectiveness of any lawn tractor, and the 917.2720601 does not disappoint. It features a 42-inch cutting deck, which allows for a wide cutting path, reducing the time spent mowing large areas. The deck height can be easily adjusted with a simple lever, providing six different height positions. This feature allows users to achieve the perfect cut, whether they prefer a manicured look or a more natural appearance.

One of the standout technologies integrated into this lawn tractor is the Easy Access battery and fuel system. This design enhances user convenience by allowing quick access for maintenance checks and fuel refills. Additionally, with its hydrostatic transmission, the Craftsman 917.2720601 offers smooth and reliable speed control, making it easy for users to navigate different terrains without any hassle.

Comfort is also a priority with this model. The tractor features an adjustable high back seat, designed to provide optimum support during prolonged use. Large, durable wheels ensure stability and traction on uneven ground, enhancing the overall mowing experience.

Safety features are another important aspect of this tractor. It includes a safety switch that prevents operation when the seat is unoccupied, reducing the risk of accidents. The easy-to-use controls are intuitively designed, allowing even novice users to operate the tractor with confidence.

In conclusion, the Craftsman 917.2720601 is a well-rounded lawn tractor that offers a combination of power, versatility, and comfort. With its robust engine, efficient cutting deck, user-friendly features, and safety technologies, it's an ideal choice for anyone looking to achieve a beautifully maintained lawn with ease. Whether for small or large yards, this tractor is equipped to meet a variety of mowing needs.
Top Page Image Contents