Craftsman 917.272057 To Level Mower Housing, SIDE-TO-SIDE Adjustment, FRONT-TO-BACK Adjustment

Page 22

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure

tires are properly inflated (See "PROD-

UCT SPECIFICATIONS" section of this

manual). If tires are over or

underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of

mower to ground. Distance "A" on both sides of mower should be the

same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift

link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjust- ing.

Bottom

Edge of

Bottom

Edge of

Mower

to Ground

Mower to

Ground

\

 

 

/

Suspension

,.,Arm

Lift Link

ustment

Nut

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side-to- side,If the following front4o-back adjust- ment is necessary, be sure to adjust both

Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjust- ments, check that both front links are

equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut "E" on both front links an equal number of turns.

•When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nuts "F" against trunnion on both front links.

•To raise front of mower, loosen nut "F" from trunnion on both front links. Tighten nut "E" on both front links an equal number of turns.

•When distance "D" is 1/8" to 1/2" lower

at front than rear, tighten nut "F" against trunnion on both front links.

•Recheck side-to-side adjustment.

Oo\_ ,. o _ Mandrel

BOTH FRONT LINKS MUST BE EQUAL

IN LENGTH

/

/

Nu, )- Nut "E"

front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower housing should be adjusted so

that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in

its highest position.

Ero_t- Links

Trunnion

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Lawn Tractor Sears Craftsman Help Line 5 am 5 pro, Mon- SatMaintenanceSchedule Parts Ordering Limited 90 DAY Warranty on BatteryGeneral Operation II. SlopeDo not IV. Service Ill. ChildrenWash hands after handling Filter Pints Filter 3.5 Pints Product SpecificationsRepair Agreement GAPWheel Insert Before Removingtractor Tools Required for AssemblyCheck Battery Attach Steering WheelPlace gearshift lever in neutral N position Install SeatTo Drivetractor OFF Skid See Operation section for location Check Tire Pressure ChecklistInstall Mulcher Plate Check Deck LevelnessH L Attachment Clutch Lever Used KnowyourtractorLift Parking Brake Lever Locks clutchTo SET Parking Brake To Adjust Mower Cutting HeightHowto Useyourtractor To USE Throttle ControlTo Operate on Hills To Adjust Gauge WheelsTo Operate Mower To TransportTowing Carts and Other Attachm Ents Before Starting the EngineTo Start Engine Check Engine OIL LevelMOWlNGTIPS Mulching MowingtipsTractor General Recommendations Lubrication ChartBefore Each USE PurposeTractor Belts Clean AIR ScreenClean AIR INTAKE/COOLING Areas Transaxle CoolingEngine OIL Filter AIR FilterSpark Plugs MufflerTractor To Remove Mower CleaningTo Install Mower Mower will be easier to remove fromFRONT-TO-BACK Adjustment To Level Mower HousingSIDE-TO-SIDE Adjustment Both Front Links Must be Equal LengthWith Parking Brake Engaged To Adjust BrakeTo Replace Mower Blade Drive Belt To Replace Motion Drive BeltTo Adjust Steering Wheel Align Ment Transaxle Gear Shift Lever Neutral AdjustmentTo Start Engine with a Weak Battery Front Wheel TOE-IN/CAMBERInterlocks and Relays Replacing BatteryTo Replace Headlight Bulb To Replace FuseEngine To Adjust Throttle Control CableTo Adjust Carburetor Acceleration TestEngine OIL BatteryFuel System CylindersProblemcause Troubleshooting ChartCorrection Vibration Throttle in Choke positionExcessive Engine ContinuesTroubleshooting Problem CauseTractor -- Model Number Schematic Ignition SwitchTractor - Model Number Electrical Tractor -- Model Number Electrical Bolt Hex Hd 1/4-20unc x 3/4Tractor - Model Number 917.272057 Chassis and Enclosures 176554 Tractor --MODEL Number Chassis and Enclosures206 Tractor - Model Number Ground Drive Tractor - Model Number Grounddrive Tractor - Model Number 917.272057 Steering Assembly 139768 SteeringWheel 175131 TRACTOR-- Model Number 917.272057 Steering Assembly32 130465 Sod, Tie Spark Arrester TRACTOR-- Model Number EngineOptional Equipment 137040 Line, FuelKEY Part Tractor - Model Number Seat AssemblyDescription Wheels & Tires KEY Part NO. NO. Description Decal, Replacement 146046Tractor -- Model Number Decals 65139Tractor - Model Number Lift Assembly 159460Tractor - Model Number Mower DeckTractor -- Model Number Mowerdeck KEY Part Description NO. no+--0 ID x.031W 772147 Transaxle Cover790079 780199Ylinder HEAD, Valve and Breather Exhaust KEY Part DescriptionValve 12-018-01-SAIR Intake J KEY Part NO. no PinionOIL PAN / Lubrication Kohler ENGINE-MODEL Number CV460, Type Number IncludesCrankshaftexhaust Fuel System 12-041-03-S Page Page Page Suggested Guide for Sighting Slopes for Safe Operation Get it fixed, at your home or ours 6aJ.-11 p.m., 7daysaweek

917.272057 specifications

The Craftsman 917.272057 is a riding lawn mower designed for homeowners who seek an efficient and reliable solution for maintaining their lawns. With its powerful engine and advanced features, it stands out as a versatile tool for lawn care.

One of the main highlights of the Craftsman 917.272057 is its robust 19.5 HP Briggs & Stratton engine. This powerful engine not only provides ample power for cutting grass efficiently but also ensures smooth operation across various terrains. The automatic transmission further enhances the user experience by allowing for seamless speed adjustments without the need for manual shifting.

The mower showcases a cutting deck width of 42 inches, making it suitable for medium to large yards. This size strikes a balance between maneuverability and efficiency, enabling users to cover larger areas while navigating around obstacles such as trees and flower beds. The cutting height can be easily adjusted with a simple lever, allowing users to customize grass length according to their preferences and seasonal needs.

One of the standout features of the Craftsman 917.272057 is its mulching capability. The mower comes equipped with a mulching kit, which allows users to finely chop grass clippings, returning nutrients to the soil. This not only promotes a healthier lawn but also reduces the need for bagging or disposal of clippings.

The construction of the 917.272057 is designed with durability in mind. Its heavy-duty frame and reinforced cutting deck ensure longevity, even when used on varied landscapes. Furthermore, the comfortable high-back seat and easy-to-reach controls enhance operator comfort during longer mowing sessions.

In terms of maintenance, the Craftsman 917.272057 is user-friendly. Accessing the engine and other vital components for routine checks and servicing is straightforward, making it easier for owners to ensure optimal performance throughout the mowing season.

In summary, the Craftsman 917.272057 is a powerful and efficient riding lawn mower equipped with essential features that cater to the diverse needs of lawn care. With a robust engine, adjustable cutting deck, mulching capabilities, and user-friendly design, it offers a comprehensive solution for homeowners seeking an effective way to keep their lawns looking pristine. Whether tackling a small yard or a larger property, this mower combines performance, comfort, and durability, making it a valuable addition to any homeowner's gardening arsenal.
Top Page Image Contents