Craftsman 917.272057 owner manual Battery, Fuel System, Engine OIL, Cylinders

Page 27

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or _k ore.

CAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter

storage. When mower is to be stored for a period of time, clean it thoroughly, remove arl dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Mainte- nance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see

"TO CLEAN BATTERY AND TERMI- NALS" in the Maintenance section of this manual).

•After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential

fuel system parts such as carburetor, fuel hose, or tank during storage.

Also, experiance indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the

fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or

storage container. Always follow the mix ratio found on stabilizer container. Run

engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach

the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to "START" position for a few seconds to distribute oil.

4.Reprace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows conden-

sation to form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Sears Craftsman Help Line 5 am 5 pro, Mon- Sat Lawn TractorLimited 90 DAY Warranty on Battery MaintenanceSchedule Parts OrderingII. Slope General OperationDo not Ill. Children IV. ServiceWash hands after handling GAP Product SpecificationsRepair Agreement Filter Pints Filter 3.5 PintsWheel Insert Attach Steering Wheel Tools Required for AssemblyCheck Battery Before RemovingtractorInstall Seat Place gearshift lever in neutral N positionTo Drivetractor OFF Skid See Operation section for location Check Deck Levelness ChecklistInstall Mulcher Plate Check Tire PressureH L Parking Brake Lever Locks clutch KnowyourtractorLift Attachment Clutch Lever UsedTo USE Throttle Control To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking BrakeTo Transport To Adjust Gauge WheelsTo Operate Mower To Operate on HillsCheck Engine OIL Level Before Starting the EngineTo Start Engine Towing Carts and Other Attachm EntsMulching Mowingtips MOWlNGTIPSPurpose General Recommendations Lubrication ChartBefore Each USE TractorTractor Transaxle Cooling Clean AIR ScreenClean AIR INTAKE/COOLING Areas BeltsMuffler AIR FilterSpark Plugs Engine OIL FilterMower will be easier to remove from CleaningTo Install Mower Tractor To Remove MowerBoth Front Links Must be Equal Length To Level Mower HousingSIDE-TO-SIDE Adjustment FRONT-TO-BACK AdjustmentTo Replace Motion Drive Belt To Adjust BrakeTo Replace Mower Blade Drive Belt With Parking Brake EngagedFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever Neutral AdjustmentTo Start Engine with a Weak Battery To Adjust Steering Wheel Align MentTo Replace Fuse Replacing BatteryTo Replace Headlight Bulb Interlocks and RelaysAcceleration Test To Adjust Throttle Control CableTo Adjust Carburetor EngineCylinders BatteryFuel System Engine OILTroubleshooting Chart ProblemcauseCorrection Engine Continues Throttle in Choke positionExcessive VibrationProblem Cause TroubleshootingIgnition Switch Tractor -- Model Number SchematicTractor - Model Number Electrical Bolt Hex Hd 1/4-20unc x 3/4 Tractor -- Model Number ElectricalTractor - Model Number 917.272057 Chassis and Enclosures Tractor --MODEL Number Chassis and Enclosures 176554206 Tractor - Model Number Ground Drive Tractor - Model Number Grounddrive Tractor - Model Number 917.272057 Steering Assembly TRACTOR-- Model Number 917.272057 Steering Assembly 139768 SteeringWheel 17513132 130465 Sod, Tie 137040 Line, Fuel TRACTOR-- Model Number EngineOptional Equipment Spark ArresterTractor - Model Number Seat Assembly KEY PartDescription 65139 Decal, Replacement 146046Tractor -- Model Number Decals Wheels & Tires KEY Part NO. NO. Description159460 Tractor - Model Number Lift AssemblyMower Deck Tractor - Model NumberKEY Part Description NO. no Tractor -- Model Number Mowerdeck+--0 780199 772147 Transaxle Cover790079 ID x.031WYlinder HEAD, Valve and Breather 12-018-01-S KEY Part DescriptionValve ExhaustAIR Intake J Pinion KEY Part NO. noOIL PAN / Lubrication Includes Kohler ENGINE-MODEL Number CV460, Type NumberCrankshaftexhaust Fuel System 12-041-03-S Page Page Page Suggested Guide for Sighting Slopes for Safe Operation 6aJ.-11 p.m., 7daysaweek Get it fixed, at your home or ours

917.272057 specifications

The Craftsman 917.272057 is a riding lawn mower designed for homeowners who seek an efficient and reliable solution for maintaining their lawns. With its powerful engine and advanced features, it stands out as a versatile tool for lawn care.

One of the main highlights of the Craftsman 917.272057 is its robust 19.5 HP Briggs & Stratton engine. This powerful engine not only provides ample power for cutting grass efficiently but also ensures smooth operation across various terrains. The automatic transmission further enhances the user experience by allowing for seamless speed adjustments without the need for manual shifting.

The mower showcases a cutting deck width of 42 inches, making it suitable for medium to large yards. This size strikes a balance between maneuverability and efficiency, enabling users to cover larger areas while navigating around obstacles such as trees and flower beds. The cutting height can be easily adjusted with a simple lever, allowing users to customize grass length according to their preferences and seasonal needs.

One of the standout features of the Craftsman 917.272057 is its mulching capability. The mower comes equipped with a mulching kit, which allows users to finely chop grass clippings, returning nutrients to the soil. This not only promotes a healthier lawn but also reduces the need for bagging or disposal of clippings.

The construction of the 917.272057 is designed with durability in mind. Its heavy-duty frame and reinforced cutting deck ensure longevity, even when used on varied landscapes. Furthermore, the comfortable high-back seat and easy-to-reach controls enhance operator comfort during longer mowing sessions.

In terms of maintenance, the Craftsman 917.272057 is user-friendly. Accessing the engine and other vital components for routine checks and servicing is straightforward, making it easier for owners to ensure optimal performance throughout the mowing season.

In summary, the Craftsman 917.272057 is a powerful and efficient riding lawn mower equipped with essential features that cater to the diverse needs of lawn care. With a robust engine, adjustable cutting deck, mulching capabilities, and user-friendly design, it offers a comprehensive solution for homeowners seeking an effective way to keep their lawns looking pristine. Whether tackling a small yard or a larger property, this mower combines performance, comfort, and durability, making it a valuable addition to any homeowner's gardening arsenal.
Top Page Image Contents