Craftsman 917.272057 Before Starting the Engine, To Start Engine, Check Engine OIL Level

Page 15

TOWING CARTS AND OTHER

ATTACHM ENTS

Tow only the attachments that are

recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

1.Check engine oil with tractor on level ground.

2.Unthread and remove oil fill cap/ dipstick; wipe oil off. Reinsert the dipstick into the tube and rest oil fill cap on the tube. Do not thread the cap onto the tube. Remove and read oil level. If necessary, add oil until

"FULL" mark on dipstick is reached. Do not overfill.

•For cold weather operation you should

change oil for easier starting (See "OIL VISCOSITY CHART' in the Mainte-

nance section of this manual).

•To change engine oil, see the Mainte- nance section in this manual.

ADD GASOLINE

•Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will increase carbon and lead oxide

deposits and reduce valve life). Do not

mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

IMPORTANT: When operating in temperatun_s below 32°F(0°C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

_{:_WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for

additional information. Never use engine or carburetor cleaner products in the fuel _k or permanent damage may occur.

CAUTION: Fill to bottom of gas tank filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

1.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

2.Place gear shift lever in neutral (N) position.

3.Move attachment clutch to "DISEN- GAGED" position.

4.Move throttle control to choke position. NOTE: Before starting, read the warm and cold starting procedures below.

5.Insert key into ignition and turn key clockwise to "START' position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and

try again. If engine still does not start, move the throttle control back to the

choke position and retry.

WARM WEATHER STARTING (50 ° F and above)

6.When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Sears Craftsman Help Line 5 am 5 pro, Mon- Sat Lawn TractorLimited 90 DAY Warranty on Battery MaintenanceSchedule Parts OrderingII. Slope General OperationDo not Ill. Children IV. ServiceWash hands after handling GAP Product SpecificationsRepair Agreement Filter Pints Filter 3.5 PintsWheel Insert Attach Steering Wheel Tools Required for AssemblyCheck Battery Before RemovingtractorInstall Seat Place gearshift lever in neutral N positionTo Drivetractor OFF Skid See Operation section for location Check Deck Levelness ChecklistInstall Mulcher Plate Check Tire PressureH L Parking Brake Lever Locks clutch KnowyourtractorLift Attachment Clutch Lever UsedTo USE Throttle Control To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking BrakeTo Transport To Adjust Gauge WheelsTo Operate Mower To Operate on HillsCheck Engine OIL Level Before Starting the EngineTo Start Engine Towing Carts and Other Attachm EntsMulching Mowingtips MOWlNGTIPSPurpose General Recommendations Lubrication ChartBefore Each USE TractorTractor Transaxle Cooling Clean AIR ScreenClean AIR INTAKE/COOLING Areas BeltsMuffler AIR FilterSpark Plugs Engine OIL FilterMower will be easier to remove from CleaningTo Install Mower Tractor To Remove MowerBoth Front Links Must be Equal Length To Level Mower HousingSIDE-TO-SIDE Adjustment FRONT-TO-BACK AdjustmentTo Replace Motion Drive Belt To Adjust BrakeTo Replace Mower Blade Drive Belt With Parking Brake EngagedFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever Neutral AdjustmentTo Start Engine with a Weak Battery To Adjust Steering Wheel Align MentTo Replace Fuse Replacing BatteryTo Replace Headlight Bulb Interlocks and RelaysAcceleration Test To Adjust Throttle Control CableTo Adjust Carburetor EngineCylinders BatteryFuel System Engine OILTroubleshooting Chart ProblemcauseCorrection Engine Continues Throttle in Choke positionExcessive VibrationProblem Cause TroubleshootingIgnition Switch Tractor -- Model Number SchematicTractor - Model Number Electrical Bolt Hex Hd 1/4-20unc x 3/4 Tractor -- Model Number ElectricalTractor - Model Number 917.272057 Chassis and Enclosures Tractor --MODEL Number Chassis and Enclosures 176554206 Tractor - Model Number Ground Drive Tractor - Model Number Grounddrive Tractor - Model Number 917.272057 Steering Assembly TRACTOR-- Model Number 917.272057 Steering Assembly 139768 SteeringWheel 17513132 130465 Sod, Tie 137040 Line, Fuel TRACTOR-- Model Number EngineOptional Equipment Spark ArresterTractor - Model Number Seat Assembly KEY PartDescription 65139 Decal, Replacement 146046Tractor -- Model Number Decals Wheels & Tires KEY Part NO. NO. Description159460 Tractor - Model Number Lift AssemblyMower Deck Tractor - Model NumberKEY Part Description NO. no Tractor -- Model Number Mowerdeck+--0 780199 772147 Transaxle Cover790079 ID x.031WYlinder HEAD, Valve and Breather 12-018-01-S KEY Part DescriptionValve ExhaustAIR Intake J Pinion KEY Part NO. noOIL PAN / Lubrication Includes Kohler ENGINE-MODEL Number CV460, Type NumberCrankshaftexhaust Fuel System 12-041-03-S Page Page Page Suggested Guide for Sighting Slopes for Safe Operation 6aJ.-11 p.m., 7daysaweek Get it fixed, at your home or ours

917.272057 specifications

The Craftsman 917.272057 is a riding lawn mower designed for homeowners who seek an efficient and reliable solution for maintaining their lawns. With its powerful engine and advanced features, it stands out as a versatile tool for lawn care.

One of the main highlights of the Craftsman 917.272057 is its robust 19.5 HP Briggs & Stratton engine. This powerful engine not only provides ample power for cutting grass efficiently but also ensures smooth operation across various terrains. The automatic transmission further enhances the user experience by allowing for seamless speed adjustments without the need for manual shifting.

The mower showcases a cutting deck width of 42 inches, making it suitable for medium to large yards. This size strikes a balance between maneuverability and efficiency, enabling users to cover larger areas while navigating around obstacles such as trees and flower beds. The cutting height can be easily adjusted with a simple lever, allowing users to customize grass length according to their preferences and seasonal needs.

One of the standout features of the Craftsman 917.272057 is its mulching capability. The mower comes equipped with a mulching kit, which allows users to finely chop grass clippings, returning nutrients to the soil. This not only promotes a healthier lawn but also reduces the need for bagging or disposal of clippings.

The construction of the 917.272057 is designed with durability in mind. Its heavy-duty frame and reinforced cutting deck ensure longevity, even when used on varied landscapes. Furthermore, the comfortable high-back seat and easy-to-reach controls enhance operator comfort during longer mowing sessions.

In terms of maintenance, the Craftsman 917.272057 is user-friendly. Accessing the engine and other vital components for routine checks and servicing is straightforward, making it easier for owners to ensure optimal performance throughout the mowing season.

In summary, the Craftsman 917.272057 is a powerful and efficient riding lawn mower equipped with essential features that cater to the diverse needs of lawn care. With a robust engine, adjustable cutting deck, mulching capabilities, and user-friendly design, it offers a comprehensive solution for homeowners seeking an effective way to keep their lawns looking pristine. Whether tackling a small yard or a larger property, this mower combines performance, comfort, and durability, making it a valuable addition to any homeowner's gardening arsenal.
Top Page Image Contents