Craftsman 917.272054 To Adjust Gauge Wheels, To Operate Mower, To Operate on Hills, To Transport

Page 14

•The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches dudng hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6 inches in height should be mowed twice, Make the first cut

_I_CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.

Attachment

ClutchLeverAttachemnt

=Engaged"High

Position, Position

relatively high; the second to desired height,

TO ADJUST GAUGE WHEELS

Gauge wheels are propedy adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions.

NOTE: Adjust gauge wheels with tractor on a flat level surface.

1.Adjust mower to desired cutting height (See _TO ADJUST MOWER CUTTING

HEIGHT" in the Operation section of this manual).

2.With mower in desired height of cut

position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole with shoulder bolt, 3/ 8 washer, and 3/8-16 Iocknut and tighten securely.

3.Repeat for opposite side installing

gauge wheel in same adjustment hole.

Gauge

Wheel

3/8-16- Locknut

Shoulder

3/8_/_Bolt

Gauge Wheel

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

1.Select desired height of cut.

2.Start mower blades by engaging attachment clutch control.

TO STOP MOWER BLADES - disengage attachment clutch control.

Low

Position

Position

Deflector

Shield

TO OPERATE ON HILLS

_CAUTION: Do not drive up or down hills with slopes greater than 15" and do not drive across any slope,

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills,

•If slowing is necessary, move throttle control lever to slower position.

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Make all tums slowly.

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

•Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hoodfrom damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

t4

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Lawn Tractor For answers to your questionsLimited 90 DAY Warranty on Battery I1. Slope Operation General OperationMow only in daylight or good artificial light IV. Service Cancer and birth defects or other repro- ductive harm Productspecifications Ooo Before Removing Tractor from Skid Attachsteeringwheel Install Seat Lower seat into operating position and sit in seatChecktire Pressure Install Mulcher PlateTo Convertto Bagging or Discharging Check Deck LevelnessBattery Reverse Forward Fast Ammeter Indicates charging + or discharging of battery KnowyourtractorStopping To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking Brake Ground DriveTo Operate on Hills To Adjust Gauge WheelsTo Operate Mower To TransportADD Gasoline Towing Carts and Other AttachmentsBefore Starting the Engine Check Engine OIL Level To Start EngineMulching Mowingtips Before Each USE Lubrication ChartGeneral Recommendations Tractor Clean AIR INTAKE/COOLING Areas To Clean Battery and TerminalsClean AIR Screen BeltsEngine OIL Filter To Service CartridgeAIR Filter IN-LINE Fuel FilterTo Remove Mower CleaningTo Install Mower Raise attachment lift lever to its highest positionTo Level Mower Housing SIDE-TO-SIDE AdjustmentPulley To Adjust BrakeTo Replace Mower Blade Drive Belt To Replace Motion Drive BeltTo Adjust Steering Wheel ALIGN- Ment Transaxle Gear Shift Lever Neutral AdjustmentTo Start Engine with a Weak Battery To Remove Wheel for RepairsTo Replace Headlight Bulb Replacing BatteryTo Remove Hood and Grill Assembly Interlocks and RelaysTo Adjust Throttle Control Cable To Adjust CarburetorEngine Fuel System To Clean Battery and TermiTractor Engine OILCause TroubleshootingchartProblem CorrectionTroubleshooting Chart Problem Cause For 30 seconds before Troubleshooting Chart ProblemCause Correction Stopping engineSchematic TCR- Model NumberTRACTOR- -MODEL NUM BER Electrical TRACTOR-- Model Number Electrical NO. NO,DESCRIPTIONTractor - Model Number 917.272054 Chassis and Enclosures TRACTOR- -MODELNUMBER917.272054 Chassisandenclosures KEY Part NO, NO, DescriptionTRACTOR- -MODEL Number Ground Drive Shift Rate TRACTOR- Model Number Ground DriveX .1645/1865 TRACTOR--MODEL Number Steering Assembly TRACTOR- Model Number 917.272054 Steeringassembly KEY Part NO. NO.DESCRIPTIONTRACTOR--MODELNUMBER917.272054 Engine KEY Part DescriptionTRACTOR-- MODELNUMBER917.272054 Seatassembly Wheels & Tires DecaJ, V-Belt SchematicTRACTOR- Model Number Decals 99904TRACTOR- Model Number Liftassembly TRACTOR-- Model Number Mowerdeck TRACTORMODELNUMBER917--.272054 Mowerdeck STD693107Page Ring TRACTOR--MODELNUMBER917.272054PEERLESSTRANSAXLE- Model NUMBER206-545C Oil Seal 9 1Cylinder HEAD, Valve and Breaiieri Crankcasi Gasket 25-186-01-S14-0 Blower Housing Baffles KEY Part Descripon 25-086-47.SStarting System Engine Controls OIL PAN / Lubrication KEY Part NO. NO.DESCRIPTION Crankshaft Available ExhausPage Page Page Suggested Guide for Sighting Slopes for Safe Operation 3s6-7278 Sears,com/patsdirect 178457 2.20,01 RD

917.272054 specifications

The Craftsman 917.272054 is a robust and efficient riding lawn mower designed to make lawn maintenance a breeze. This machine features a powerful 24 HP Kohler engine, delivering reliable performance and significant torque, enabling it to tackle even the toughest grass and terrain with ease. One of the standout characteristics of the 917.272054 is its hydrostatic transmission, which offers smooth and variable speed control. This allows the operator to maneuver easily without the need for gear shifting, providing a more comfortable mowing experience.

Equipped with a 54-inch cutting deck, the Craftsman 917.272054 allows for a wide cutting path, significantly reducing mowing time, especially for larger lawns. The cutting deck features multiple height adjustments, ranging from 1.5 to 4 inches, allowing users to achieve the perfect cut tailored to the specific needs of their grass type. This adaptability promotes healthy grass growth and enhances the overall appearance of the lawn.

The mower also showcases a rugged and durable construction, making it suitable for various conditions. The front axle is designed for added stability, while the reinforced deck is engineered to withstand the rigors of frequent use. Another notable feature is the comfortable high-back seat that provides excellent lumbar support, essential for long mowing sessions.

For enhanced convenience, the Craftsman 917.272054 includes an easy-to-use dashboard with essential controls conveniently located for quick adjustments while operating. The ignition switch is designed for easy starting, and the mower includes a sturdy grass collection system for effortless cleaning and maintenance.

Additionally, this lawn mower is compatible with various attachments, including baggers, mulch kits, and other accessories, allowing users to customize their mowing experience based on their lawn care needs. Safety features like the operator presence control ensure that the mower will shut off if the operator leaves the seat, adding an extra layer of protection.

Overall, the Craftsman 917.272054 stands out as an exemplary choice for homeowners seeking a reliable and efficient lawn mower that combines power, functionality, and user-friendly design. With its advanced features and technologies, it makes lawn maintenance not only easier but also more enjoyable.
Top Page Image Contents