Craftsman 917.272054 AIR Filter, To Service Cartridge, Engine OIL Filter, IN-LINE Fuel Filter

Every 100 beurs of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary. Make sure the cooling shrouds are reinstalled.

NOTE: Operating the engine with a blocked grass screen, dirty or plugged coolingfins, and/or cooling shrouds removed will cause engine damage due

to overheating.

AIR FILTER

Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every 100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

1.Remove knob and cover.

2.Remove wing nut and air cleaner from base.

TO SERVICE PRE-CLEANER

3.Slide foam pre-cleaner off cartddge.

4.Wash it in liquid detergent and water.

5.Squeeze it dry in a clean cloth. Allow it to dry.

6.Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.

TO SERVICE CARTRIDGE

•Replace a dirty, bent, or damaged cartridge.

NOTE: Do not wash the paper cartridge or use pressurized air, as this will damage the cartridga.

7.Reinstall the pre-cleaner (cleaned and oiled) over the paper cartddge.

8.Reassemble air cleaner, wing nut, cover and tighten knob securely.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first.

Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS" section of this manual.

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

1.Drain oil from engine crankcase (See =TO CHANGE ENGINE OIL" in this

section of this manual, throughstep remove drain plug).

2.Remove oil filter and wipe off filter adapter.

3.Apply a thin coating of new engine oil to the rubber gasket on replacement oil filter.

4.Install replacement oil filter on filter adapter. Turn oil filter clockwise until rubber gasket contacts the filter adapter, _hen tighten filter an addi- tional 1/2 turn.

5.Fill crankcase with new oil (See "TO CHANGE ENGINE OIL" in thissection of this manual). For approximate capacity see "PRODUCT SPECIFICA-

TIONS" section of this manual.

6.Start the engine and check for oil leaks. Correct any leaks before placing engine into full operation.

Oil Filter

IN-LINE FUEL FILTER

The fuel filter should be replaced once each season. If fuel fifier becomes

	___._ver		Knob
Air Cleaner___._			_._g	Nut
Cover	( _	_,______r_Rubber
Foam_	-	_	_ Grommet
Pre- _		,-r_\	/
Cleaner			Air Cleaner
er_	"_._pA_pCer			Cartridge
A"			Air Cleaner

MUFFLER

Inspect and replace corroded muffler and spark an'ester(if equipped) as it could create a fire hazard and/or damage.

clogged, obstructing fuel flew to carbure- tor, replacement is required.

1.With engine cool, remove filter and plug fuel line sections.

2.Place new fuel filter in position in fuel

line with arrow pointing towards carburetor.

3, Be sure there are no fuel line leaks and clamps are properly positioned.

4.Immediately wipe up any spilled gasoline.

FC__Clamp

20