Craftsman 917.27182 manual Towing Carts and Other Attachments, ADD Gasoune, To Start Engine

Page 16

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER

ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor, Use common sense when towing. Too heavy of a load, white on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STAFITINGTHE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

1.Check engine oil with tractor on level ground.

2.Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw

cap tight, wait for a few seconds, remove and read oil level. If neces-

sary, add oil until "FULL" mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier stading (See "OIL

VISCOSITY CHART" in the Mainte- nance section of this manual).

•To change engine oil, see the Mainte- nance section in this manual.

ADD GASOUNE

•Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

IMPORTANT: When operating in temperatures below 32°F(0°C), use fresh, clean winter grade gasoline to bep insure good cold weather starting.

_llcW,A ,RN!NG,: Expe,dence indicats.sthat onol eleneeo tuels tca,eo gasonol or

using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

_k CAUTION: Fill to bottom of Qas tank filler neck. Do not overfill. Wip_ off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

TO START ENGINE

When starlingthe engine for the firsttime or if the engine has run out of fuel, it willtake extra crankingtime to move fuel from the tank to the engine.

1.Be sure freewheel control is in the transmission engaged position.

2.Sit on seat in operating position, depress clutcWbrake pedal and set parking brake.

3.Place motion control lever in neutral

(N)position.

4.Move attachment clutch to =DISEN-

GAGED" position.

5.Move throttle control to fast position

6.Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control

may not be needed.

NOTE: Beforestarting,read the warm and cold startingprocedures below.

7.Insert key into ignition and turn key clockwise to "START" position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute.

If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Icrrftsmrni For answers to your questions About this product, CallLimited 90 DAY Warranty on Battery II. Slope Operation General OperationDo not IV. Service IiichildrenThat may obscure vision Mower blades are sharp and can cutSafety is Involved Neutral, you may lose control of the tractorProduct Specifications Repair AgreementSeat Keys Video CassetteOil DrainTube For FutureUseBefore Removing Tractor from Skid Attach Steering Wheel Install Seat If previously removed #CHECKLIST All assembly instructions have beenENG,NEONENG,NEOFFOLFRESSUREL,G.TSONO%MF Indicator KnowyourtractorClutch BrakePedal Height MotionTo Adjust Mower Cutting Height Howto Useyourtractor To SET Parking BrakeStopping Mower Blades Ground DriveTo Adjust Gauge Wheels To Operate MowerTo Operate on Hills To TransportViscosity Chart in the Mainte- nance section of this manual Towing Carts and Other AttachmentsBefore Stafitingthe Engine Check Engine OIL Level ADD GasouneWarm Weather Starting 50 F and above SlowlyAutomatic Transmission Warm UP PurgetransmissionMowingtips Mulching MowingtipsLubrication Chart All adjustmentsin the ServiceGeneral Recommendations Zerk SpindleBrake Operation TiresOperator Presence System Blade CareTo Clean Battery and Terminals BeltsTransaxle Cooling Tranbaxle Pump FluidCartridge Cleaning Aution Before Performing ANY Service or AdjustmentsTo Install Mower Tractor To Remove MowerTo Level Mower Housing SIDE-TO-SIDE AdjustmentTo Replace Mower Blade Drive Belt Belt RemovalTransaxle Motion Control Lever Neutral Adjustment To Adjust BrakeTo Replace Motion Drive Belt To Adjust Steering Wheel Replacing BatteryTo Start Engine with Weak TransmissionTo Remove Hood and Grill Assembly To Adjust Throttle Control CableTo Adjust Choke Control Interlocks and RelaysTo Adjust Carburetor Preliminary SettingFinal Setting RPMTractor Loose or damaged wiring Carburetor out of adjustment ProblemDirty air filter Dirtyfuel filter Stale or dirtyfuelTroubleshooting Chart CauseOrrection Replace blade Tighten blade boltBlownfuse Place freewheel controlinEngaged position Replace motiondrive beltSchematic Tractor -- Model NumberElectrical Tractor - Model NumberElectrical KEY Part DescriponTractor - Model Number Chassis and Enclosures Tractor - Model Number 917.271820 Chassis and Enclosures KEY Part NO. NO.DESCRIPTIONGROUNDDRIVETRACTOR- MODELNUMBER917.271820 Tractor -- Model Number 917,271820 Ground Drive KEY PartTractor - Model Number 917.271820 Steering Assembly KEY Part Description Optional Equipment Tractor - Model Number 917,271820Spark Arrester KEY Paitt NO. NO.DESCRIPTION SEAT AssEMBLY Tractor MODELNUMBER917.271820Decals Wheels & TiresTractor - Model Number Lift Assembly Lift Assembly Tractor . Model Number Tractor - Model Number Mower Deck Spacer 2629J\ \ 20w-50 2911 LO. Ownersmanual11019LABELKIT TRACTOR-- MODELNUMBER917.271820 971I 9345101 513 802 783 1051 803 797 544 801Gasket SET 634 1770 51A 16390569271411 272490 Page Page Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillGet it fixed, at your home or ours Rev 12.8.00 TR

917.27182 specifications

The Craftsman 917.27182 is a versatile and reliable lawn tractor designed for homeowners who seek efficiency and ease in maintaining their yards. Known for its robust construction and innovative features, this lawn tractor is designed to handle a variety of tasks with ease.

One of the standout features of the Craftsman 917.27182 is its powerful engine. Equipped with a 17.5 HP Briggs & Stratton engine, this tractor provides plenty of power to tackle even the toughest mowing conditions. The engine is designed for smooth operation and is built for longevity, making it a dependable choice for lawn care.

The cutting deck of the Craftsman 917.27182 measures 42 inches, offering a wide cutting path that allows users to cover more ground in less time. The deck is made of durable materials, ensuring that it can withstand the rigors of regular use. Additionally, it features a multi-blade design that delivers a clean and precise cut, promoting healthy grass growth.

Another significant characteristic of this lawn tractor is its 6-speed transmission. The automatic transmission allows for smooth shifting between gears, providing users with the flexibility to adjust their speed based on the terrain and grass height. This feature enhances maneuverability and improves overall mowing efficiency.

The Craftsman 917.27182 is equipped with a comfortable and ergonomic seat, designed to reduce fatigue during extended use. The seat can be easily adjusted to accommodate different user heights, ensuring optimal comfort for everyone. Furthermore, the tractor has a tight turning radius, making it easy to navigate around obstacles and flower beds.

In terms of technological advancements, this model incorporates a robust front axle and durable rear wheels, designed for stability and traction. The inclusion of easy-access controls allows users to operate the tractor without difficulty, enhancing the overall user experience.

Maintenance is made simple with the Craftsman 917.27182, as it features an easily accessible oil filter and fuel tank, allowing for hassle-free servicing. This focus on convenience extends to the design of the mower deck, which can be tilted for easier cleaning after use.

Overall, the Craftsman 917.27182 lawn tractor combines power, durability, and user-friendly features to create an impressive tool for lawn care. Its blend of technology and thoughtful design makes it a reliable choice for any homeowner looking to maintain a beautiful lawn with minimal effort.
Top Page Image Contents