Positive terminal must be connected first
to prevent sparking from accidental grounding.
1.Lift hood to raised position.
2.Remove terminal guard.
3.Disconnect BLACK battery cable then
RED battery cable and carefully remove battery from tractor.
4.Install new battery with terminals in same position as old battery.
5.Reinstall terminal guard.
6.First connect RED battery cable to positive (+) baMery terminal with hex bolt and keps nut as shown. Tighten securely,
7.Connect BLACK grounding cable to negative
8.Close terminal access doors.
9.Close hood.
Terminal | Keps | Hex |
Access | i_:; : | "Bolt |
Door _ |
| Positive |
Terminal |
| Cable |
| (Black) | Cable |
TO REPLACE HEADLIGHT BULB 1, Raise hood.
2, Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL ASSEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
4.To replace, reverse above procedure.
I.
/Hood
.,f
| _ | Headlight Wire |
: | _ | Connector |
•/ | _Y/ |
|
ENGINE
Maintenance, repair, or replacement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If
adjustment is necessary, proceed as follows:
1.With engine not running, move throttle control lever to fast position.
2.Check that swivel is against side of quarter circle. If it is not, loosen cable clamp screw and pull cable back until swivel is against quarter circle.
Tighten cable clamp screw securely.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If
adjustment is necessary, proceed as follows:
1.With engine not running, move choke control (located on dash panel) to full choke position.
2.Remove air cleaner cover, filter and cartridge plate to expose carburetor choke (see "AIR FILTER" in the
Maintenance section of this manual).
27