Craftsman LTS 1500 manual Tractor, Fuel System, Engine OIL, Cylinders, Other

Page 27

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more°

_WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark.

Allow the engine to cool before storing in any enclosure,

TRACTOR

Remove mower from tractor for winter storage_ When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc, Store in a clean, dry area,

1.Clean entire tractor (See "CLEANING"

in the Maintenance section of this manual).

2.inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving

parts for damage, breakage and wear. Replace if necessary

5, Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage..

•After a period of time in storage, battery

may require recharging,

°To help prevent corrosion and power leakage during long periods of storage, battery cables should be.. disconnected

and battery cleaned thoroughly (see "TO

CLEAN BATTERY AND TERMINALS" in the Maintenance section of this man-

ual) _.

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT, It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, ortank during storage, Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

,Empty the fuel tank by starting the engine and letting it run until time fuel lines and

carburetor are empty,.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season

NOTE: Fuel stabilizer is an acceptable al- ternative in minimizing the formation of fuel gum deposits during storage Add stabilizer to gasoline in fuel tank or storage container Always followthe mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor, Do not empty the gas tank and carburetor if using fuel stabilizer..

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil (See "ENGINE" in the Maintenance section of this manual),

CYLINDER(S)

1.Remove spark plug(s).

2.Pourone ounce ofoilthrough spark plug

hole(s) into cylinder(s),

3Turn ignition key to "START" position for a few seconds to distribute oil,

4.Replace with new spark plug(s).

OTHER

,Do not store gasoline from one season to another.

. Replace yourgasoline can ifyour can starts to rust. Rust and/or dirt in your gasoline will cause problem&

. If possible, store your tractor indoors and cover it to give protection from dust and dirt

•Cover your tractor with a suitable protec- tive cover that does not retain moisture

Do not use plastic Plastic cannot breathe which allows condensation to form and will

cause your tractor to rust..

IIVlPORTANT Never cover tractor while engine and exhaust areas are stili warm.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Sears Craftsman Help Line Lawn TractorDays on Battery Craftsman Limited Warranty TWO Years on TractorGeneral Operation Service Safe Handling of Gasoline II. Slope OperationIV, Towing General Service RC12YC ProductSAE API-SG-SL SAEKeys T1!f1111Install Seat Tools Required for AssemblyAssemble Extension Shaft and Boot Install Steering WheelTo Roll Tractor OFF Skid Check BatteryCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL Belts@@@@ Reverse Operation System ROS Know Your TractorTo SET TractorTo Operate on Hills Using the Reverse Operation SystemTo Operate Mower Operating in ReverseTo Start Engine Towing Carts and Other ATTACH- MentsBefore Starting the Engine Check Engine OIL Level ADD GasolineMowing Tips Every Every SEFO.E Schedule Each MaintenanceLubrication Chart EVE.YBlade Removal Blade CareLubrication BatteryTo Clean Battery and Terminals Transaxle CoolingAIR Filter CleaningClean AIR Screen IN-LINEFUEL FilterTo Remove Mower To Install MowerTo Level Mower Housing SIDE-TO-SIDE AdjustmentFRONT-TO-BACK Adjustment To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt Belt RemovalMent Interlocks and Relays Replacing BatteryTo Adjust Throttle Control Cable To Remove CABLES, Reverse OrderAcceleration Test To Adjust CarburetorPreliminary Setting Final SettingCylinders TractorFuel System Engine OILWill Problem Cause CorrectionCause Correction ProblemLoss of power Engine clicks butProblem Causecorrection Battery will not chargePoor grass discharge Engine WhenOFF 11 n 11 o 11I BiAS Para BATERiAS Lesiones graves o la muerte Generales IV, RemolquePage MIN. CCA DEL ProductoPage EL Montaje Para Hacer Rodar EL Tractor Verifique LA BATER1ALista DE Revision Revision DE LA Presion DE LASLlantas Revision DE LA Posicion ADECUA- DA DE Todas LAS Correas@@@@ Palanca DEL Embrague DEL Acceso Faiviliaricese CON SU TractorControl DE Aceleracion Macho DE LA Palanca DE LevantaMiento Para Operar EN Cerros Papa Operar LA SegadoraPara Parar LAS Cuchillas DE LA Sega Usar EL Sistema DE FUNC1ONAMIENTO AtrasAgregue Gasolina Remolque DE Carretillas O Otros AccesoriosAntes DE Hacer Arrancar EL MotorConsejos Para Segar Oo272Mantenimiento Generales TablaVerifiez Sistema Presencia Operador LlantasSistema Presencia Operador Y Siste MA FUNCIONArIENTO Atras ROSCorreas BateriaNales Enfriamiento DEL TransejeFiltro DE Combustible EN Linea Filtro DE Aceite DI=L MotorFiltro DE Aire Limpieza DE LA Rejilla DieaireSERVIClO O DE Hacer Ajustes Tractor Para Remover LA SegadoraPara Instalar LA Segadora Para Nivelar LA Caja DE LA SEGA- Dora Ajuste DE Lado a LadoAjuste Desde Adelante Hacia Atras Segadora LA Correa DE ImpulsionReles Prueba DE LA Aceleraciqn Ajuste FinalOtros Aceite DEL MotorSears PROBLEIViA CausaPero noarranca Prdida de fuerza El motor continua funcionan do Cuando el operador P6rdida de fuerzaContinuado El tractor se pon en marcha arrasEl motor tiene SearsLas cuchiltas segadoras no rotan C6sped Las luz ces delanteras noSoline Genera Rrt 17.5 F

LTS 1500 specifications

The Craftsman LTS 1500 riding mower is a powerful and efficient machine designed for homeowners seeking an effective solution for lawn maintenance. This riding mower is equipped with a range of features and technologies aimed at enhancing performance and user comfort.

One of the standout features of the LTS 1500 is its robust 15.5 horsepower engine, which provides the necessary power for tackling a variety of mowing tasks. The engine offers reliable performance, ensuring that users can easily cut through thick grass and uneven terrain without difficulty. The mower's engine is matched with a smooth-running automatic transmission, allowing for effortless speed adjustments as users navigate their lawns.

The LTS 1500 features a wide cutting deck, typically sized between 42 to 48 inches, enabling users to cover large areas quickly. Its adjustable cutting height, which can be set to various positions, provides flexibility in achieving the desired lawn height, accommodating different grass types and mowing preferences. The deck design also facilitates efficient grass clipping management, leaving behind a neat and even finish.

Craftsman incorporates innovative technologies into the LTS 1500, such as the ReadyStart system, which ensures easy starting with minimal effort. This feature eliminates the need for priming or choking, making it ideal for those who may not be familiar with traditional gas-powered engines.

Ergonomics play a key role in the LTS 1500's design, featuring a comfortable high-back seat and easy-to-reach controls that enhance the overall user experience. The compact design allows for easy maneuverability, particularly in tight spaces and around obstacles in the yard.

Durability is a significant characteristic of the Craftsman LTS 1500, built with high-quality materials to withstand the rigors of regular use. The rugged construction assures users that their investment will last for many seasons, providing consistent performance year after year.

Another notable characteristic is the mower's ease of maintenance. The design allows for straightforward access to key components, making routine maintenance tasks such as oil changes, blade sharpening, and air filter replacements hassle-free.

In summary, the Craftsman LTS 1500 riding mower combines power, efficiency, and user-friendly features, making it an excellent choice for homeowners looking to maintain their lawns effectively. With its reliable performance, advanced technologies, and robust design, the LTS 1500 stands out as a dependable companion for lawn care enthusiasts.
Top Page Image Contents