Craftsman 358.35161 manual Starting a Warm Engine, Difficult Starting or 8tatting a flooded engine

Page 9

_ILWARNING: Do not attempt to throw or drop-start the chain saw, Doing so witt put the operator at risk of serious injury due to loss of controI of the chain saw.

IMPORTANT POINTS TO REMEMBER When puIIing the starter rope, do not use the full extent of the rope as this can cause the rope to break. Do not let starter rope snap back. HoM the han- dle and let the rope rewind stowty.

For cold weather starting, start the unit at FULL CHOKE; allow the engine to warm up before squeezing the throttle trigger.

NOTE: Do not attempt to cut material with the choke/fast idle lever in the FULL CHOKE position.

STARTING A COLD ENGINE (or warm engine after running out of fuel)

NOTE: tn the following steps, when the choke/fast idle lever is pulled out to the fult extent, the correct throttte setting for starting is set automatically,

IGNITION

SWITCH

ON

Lever

1.Move ON/STOP switch to the ON position.

2.Pult choke/fast idle lever out to the

full extent (to the FULL CHOKE posi- tion).

3.Slowly press primer bulb 6 times.

4.Putt the starter rope sharply 5 times with your right hand. Then, pro- ceed to the next step.

NOTE: If the engine sounds as if it is try- ing to start before the 5th pull, stop pull- ing and immediately proceed to the next step.

5.Push the choke/fast idle lever in to the HALF CHOKE position.

CHOKE/FAST IDLE LEVER

oil iF HALF

ITm . / FULL

6.Putt the starter rope sharply with your right hand until the engine starts.

7, Allow the engine to run for approxi- mately 30 seconds. Then, squeeze and release the throttle trigger to allow engine to return to idle speed.

STARTING A WARM ENGINE

1.Move ON/STOP switch to the ON position.

2.Putt the choke/fast idle lever out to the FULL CHOKE position to set the fast idle, then push the lever in to the HALF CHOKE position.

3.Stowly press primer bulb 6 times.

4.Putt the starter rope sharply with your right hand untit the engine starts.

5.Squeeze and release throttle trigger to allow engine to return to idle speed.

DIFFICULT STARTING (or 8tatting a flooded engine)

The engine may be flooded with too much fuet if it has not started after 10

pulls.

Flooded engines can be cleared of ex- cess fuel by pushing the choke/fast idle lever in completeIy (to the OFF CHOKE position) and then following the warm engine starting procedure listed above. Ensure the ON/STOP switch is in the ON position,

Starting could require pulling the start- er rope handle many times depending on how badly the unit is flooded, If en-

gine fails to start, refer to the TROU- BLESHOOTING TABLE or call

1-800-235-5878.

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Operators Manual Plan Ahead ONE Year Full Warranty on Craftsman GAS Chain SAWMaintain Your SAW in Good Working Order Carburetor AdjustmentHandle Fuel with Caution Guard Against KickbackReduce the Chance Kickback Avoid Pinch-KickbackAvoid Putl-ln WE do not REP Chain BrakeCarton Contents AssemblyModel CHOKE/FAST Idle Lever ON/STOP SwitchPrimer Bulb Chain TensionFueling Engine Guide BAR and Chain OILStopping Your Engine Starting PositionDifficult Starting or 8tatting a flooded engine Starting a Warm EngineBraking function control Inertia activating function controlOperating Tips Felling Large Trees Tree Felling TechniquesNotch CUT and Felling the Tree Hinge holds tree on stump and helps control fallCutting a Fallen Tree Bucking Bucking Using a LOG or Support StandImportant Points Types of Cutting Used for BuckingLimbing and Pruning Iiwarning Using a support standLimbing PruningResponsibilities Hand tighten onlyt Check Chain SharpnessCheck Guide BAR Inspect and Clean Unit and Decals Clean AIR FilterCheck Chain Brake Check Fuel Mixture LevelTool8 required To Replace Chain Chain ReplacementChain Adjustment LoosenJustment Fuel System Seasonal StorageEngine OtherTroubleshooting Table Trouble CauseRemedy Remedy TroubleYour Warranty Rights What is Covered Repair orOff-road engine is purchased. Length of Coverage This war MAINTENANCE, Replacement and Repair Repair Parts Sears CHAtNSAW Model

358.35161 specifications

The Craftsman 358.35161 is a reliable and powerful gas-powered string trimmer designed for homeowners and landscaping enthusiasts alike. Known for its robust performance, this trimmer offers a blend of innovation, comfort, and efficiency.

One of the standout features of the Craftsman 358.35161 is its 25cc 2-cycle engine. This engine provides ample power to tackle tough weeds, grasses, and overgrowth while delivering a user-friendly experience. The lightweight design of this trimmer, weighing approximately 10 pounds, also enhances its maneuverability, allowing users to navigate around gardens, flower beds, and landscaping projects with ease.

The Craftsman 358.35161 incorporates a straight shaft design, which is particularly advantageous for reaching under shrubs and in tight spaces. This design not only promotes better balance and control but also allows for greater reach, making it easier to access hard-to-reach areas. The 17-inch cutting swath ensures that users can cover a significant area in a single pass, improving efficiency during use.

Comfort is a priority with the Craftsman 358.35161, as evidenced by its cushioned grip handle and adjustable shaft length. These features combine to reduce operator fatigue during extended use, allowing users to work for longer periods without discomfort.

The trimmer is equipped with a dual line, bump-feed cutting system, which makes it easy to advance the line without stopping the engine. This system also allows for quick line replacement, enabling users to get back to work with minimal downtime. The 0.095-inch line thickness ensures effective cutting power while also being durable enough to withstand regular use.

A notable technological feature of the Craftsman 358.35161 is its Easy Start System, designed to simplify the starting process. This system reduces the amount of effort needed to start the engine, allowing for a smoother, quicker ignition every time. The fuel-efficient engine also contributes to fewer emissions, making it a more environmentally friendly choice compared to older models.

In summary, the Craftsman 358.35161 is an excellent choice for anyone looking for a versatile and efficient string trimmer. With its lightweight design, powerful engine, user-friendly features, and innovative technologies, it stands out as a reliable tool for maintaining beautiful landscapes. Whether you’re tackling simple yard maintenance or more demanding landscaping tasks, the Craftsman 358.35161 proves itself to be a valuable ally in your gardening endeavors.
Top Page Image Contents